connections
ATTACHING THE TOROIDAL FERRITE CORE TO THE POWER CORD OF THE SUBWOOFER
Attaching the Toroidal ferrite core to the power cord of the subwoofer helps prevent RF interference from radio signals.
1.Pull the fixing tab of the Toroidal ferrite core to open it.
2.Make two loops around the core with the power cable of the subwoofer.
3.Attach the Toroidal ferrite core to the Subwoofer power cord as the figure
shows and press it until it clicks.
LOOPING THE POWER CABLE AROUND THE TOROIDAL CORE
Lift up to release the | Make two loops around the core | Close the lock. |
lock and open the core. | with the power cable. (Start |
|
| winding |
|
| from the core). |
|
AUTO SOUND CALIBRATION (ASC)
For your best sound experience, ASC provides
1.Place the ASC Microphone at the listening position.
•Please make sure to place the ASC mic on the actual listening point for precise adjustment.
2.Connect the ASC Microphone into the ASC IN jack on the Air Track. The Calibration starts automatically and it may take about 2 minutes.
•If you turn off the Air Track or unplug the ASC microphone before the completion message appears on the display, calibration will be cancelled and incomplete. In such a case, plug the ASC microphone into the ASC IN jack again.
•When the Calibration completes, you can choose the ASC mode by pressing the Sound Effect button on the remote control.
ASC 
microphone
▪During the ASC calibration, all other buttons do not work except the power button.
▪ASC will abort with error if you change the set’s position in the middle of ASC calibration.
12