Samsung SSA-R2000/EXP manual Initialization, Output Format

initialization

OUTPUT FORMAT

You can adjust the output format of the numeric values from the keypad.

You can select 4/8 bit Burst or 26bit Wiegand.

Adjust the format according to the controller receiving the keypad input.

1. To change the output format, use the switch on the rear of the

product. ON

1 2

2. See the table below to make adjustment as needed.

❖Output Format

SW #1	SW #2	Output Format of Card	Output Format of Keypad
ON	ON	26bit Wiegand + RS-232	8bit Burst (Default)
ON	OFF	26bit Wiegand + RS-232	26bit Wiegand + RS-232
OFF	ON	26bit Wiegand + RS-232	26bit Wiegand + RS-232
OFF	OFF	26bit Wiegand + RS-232	4bit Burst

M Switch #1 and #2 of SW are set to ON by default.

 Before you change the output format, you must disconnected the power.

INITIALIZATION

English _ 11