Lightolier Fluorescent Downlight and Wall Washer Snapin, PUSH-UP Reflector for Lens Wall Washer

lNSTALIATION OF COMPACT FLUORESCENT DOWN LIGHTS AND WALL WASHERS (CONT’D)

;2;~54CL

Page 2 of 2

A. SNAPIN

Align TABS on SOCKET CUP with openings in reflector and push in SOCKET CUP until RETAINING SPRING snaps-in (Fig. 5).

B. INSTALL WHITE TRIM RING

NOTE Omit this section If reflector is self-flanged.
1. For overlapping trim installation (Fig. 1) slip WHITE RING over
LENS TRIM as shown in Fig. 2 and 3.	REFL
2. For flangeless trim installation (Fig. 4), WHITE TRIM RING is not
required.

LENS WALL WASHER

SOCKET CUP

rJUNCTION BOX

LEAVE APPROX. 1“EXPOSED

C. PUSH-UP REFLECTOR FOR LENS WALL WASHER

1.Tilt REFLECTOR and insert SOCKET CUP into ceiling opening on side opposite JUNCTION BOX. Push REFLECTOR up leaving

approximately one inch of the REFLE~R exposed below the CEILING LINE (Fia. 10A).

2.Compress TORSl~NTITE SPRINGS on LENS TRIM by squeezing with fingem. Insert into SLOTS in REFLECTOR and push up into REFLECTOR until flush with ceiling (Fig. 11).

NOTE To remove REFLEC70R, lift LENS and pull LENS TRIM down (Fig. 12), then disengage the SOCKET CUP by daprsssing the RETAINING SPRING (Fig.5). lhrn REFLECTOR counterclockwise while pulling downward. Aftar stafling, use both hands to remove. See Fig. 7.

PUSH-UP REFLECTOR FOR OPEN WALL WASHER

1,TiltREFLECTOR and insert SOCKET CUP into ceiling opening on

side opposite JUNCTION BOX. Pivot REFLECTOR and push it up into ceilina-.-[Fia, . 13).

NOTE To remove REFLECTOR, disengage the SOCK~ CUP by daprassing the RETAINING SPRING (Fig. 5). 7urn REFLEC70R

counteroiockwise while pulling downward. After starting, use both hands to remove If dasired. Saa Fig. 7.

TITE

G

M

\

u“ WALL TO BE ILLUMINATED

FIG. 10A

OPEN WALL WASHER

JUNCTION

BOX 7

*K ~ b

D.LAMPING

Line up pins and push into socket. To relamp, carefully pull lamp straight out.

CARE AND MAINTENANCE						OF A12AK@ REFLECIOR				--	WALL TO BE ILLUMINATED
If handling of reflectors with anodized or Alzak finish is required, the
use of clean		white	or plastic film			gloves is recommended			to avoid
fingerprints.											FIG. 10B
Anodized or Alzak surfaces can be cleaned by the following methods
1.	Wipe off	with	a soft,	clean,	dry, lint-free		cloth.
2.	Wipe off	with	a soft	clean	cloth	dampened		in mild detergent
	solution. Rinse then wipe dry with lint-free cloth or paper towel.
3.	Wipe off with a clean cloth				dampened		with	a solution	of wetting
	agent and water (such as 2 oz. per gallon “PluronicL62-LF” by
	Wyandotte Products). Then wipe dry.
4.	Or use a liquid wash such				as Glass Wax”. Avoid gritty				cleaning
	agents.

FIG. 11

/--‘“’%lON

SOCKET

CUP

-Qi-REFLEcTOR

FIG. 13 FIG. 12