After Diving Care
1.Immediately submerge the housing in fresh water. While in fresh water, work the dials, levers and all the buttons, to work any remaining salt water out of the housing.
2.Remove housing from rinse tank and then simply towel dry.
Don’t abandon your Titan D100 in the rinse tank!!! It’s not uncommon for another housing or camera to be carelessly dropped into the rinse tank. Other equipment falling onto your Titan D100 can scratch ports or damage the housing body.
O-ring Care and Maintenance
O-rings are the critical component that keeps water out of the housing. Routinely inspect o-rings and replace at least once a year. If your o-rings are damaged, contact the Light & Motion service department for an o-ring replacement kit.
Follow these steps for proper o-ring care.
1)The sealing system used on the rear plate incorporates two o-rings.This is the most crit- ical area of the housing for maintenance and should be inspected before every dive.
2)Make sure the rear plate o-rings and the mating surface on the inside of the main hous- ing are clean from grit, hair, lint and anything that could potentially breach the o-ring seal.
3)After frequent diving or if o-rings appear dirty, remove o-rings and clean the grooves.To remove o-rings, use finger pressure or the rounded edge of a plastic card to lift the o- ring out of the groove.
Never use a metal object to remove an o-ring. It will cause dam- age to the o-ring and mating surface.
4)To check o-rings for damage, place the o-ring between the index finger and thumb.Then pull the o-ring through your fingers, feeling for any debris or wear.
5)If o-rings are dirty, it is best to replace them.Washing dirty o-rings with soap and water is not recommended. Soap breaks down the lubricants and will compromise the integri- ty of the seal.
6)Properly greased o-rings will help maintain sealing integrity and minimize o-ring degra- dation. Use enough grease to lubricate the o-ring thoroughly, but not so much that it will attract additional debris.
7)Clean the groove with a lint free swab or the folded edge of a paper towel.
8)Return O-ring to respective groove.
Titan D100 O-ring Replacement Kit part # 854-0129, includes two o-rings for the Rear Plate, two O-rings for a port and 1/4 oz. of O-ring grease.
Titan D100 Accessories
Titan D100 Fault Free Warranty . . . . . . . . . . . . . . .905-0200
Tetra Wetlink Sync Cord (Sea & Sea only) . . . . . . .854-0044
Titian D100 Custom Travel Case . . . . . . . . . . . . . . .775-0019
Sunray Mod Light . . . . . . . . . . . . . . . . . . . . . . . . . .850-0049
Titan Pointer Light . . . . . . . . . . . . . . . . . . . . . . . . . .854-0051
Titan D100 Electronics Replacment Kit . . . . . . . . .854-0152
Titan D100 Body Cap . . . . . . . . . . . . . . . . . . . . . . . .854-0148
Titan D100 Neoprene Dome Port Cover . . . . . . . .854-0149
Titan D100 O-ring Kit . . . . . . . . . . . . . . . . . . . . . . .854-0129
Smart Grip Battery and O-ring Kit . . . . . . . . . . . . .854-0117 Handle Thread Ring Replacement Kit . . . . . . . . . .854-0147
Handle Strobe Base Mounts . . . . . . . . . . . . . . . . . .854-0104
