Kohler CFI230J manual ±0mm

Remove the lintel from glass and remove the parking block

1. Match parking block	2. Spot drill hole positions	3. Drill holes with 6mm drill
to mark on wall

Carefully lift the assembly onto the tray. The end

of the glass panel fits into slot ‘A’ on the tray.

The wall channel end sits on the flat section of

the tray ‘B’

Adjust wall jamb until glass is parallel to the edge of the tray ‘A’ and vertical at ‘B’.

5. Screw parking block to wall	6. Re-fit lintel to glass
	and push wall mount
	on to the parking block

A

4.Plug holes

7.Secure the lintel to parking block by tightening allen screw ‘A’

A

STEP

24

B
A
Take care not to
damage pipe and
cable protruding	STEP
from wall	14

±0mm	B
A
	STEP
	15

Check the lintel is level.

If adjustment is required turn screw ‘A’

on the panel clamps to lift or lower the rail.

Note: If the lintel cannot be made level by adjusting the clamps remove the grub screws and fit the longer ones supplied in the parts pack.

When the lintel is level tighten screw ‘B’ on each panel clamp until it grips the glass.

IMPORTANT - DO NOT OVER TIGHTEN

Fit caps to lintel ‘C’

B

C

A

Spot drill through 4 fixing holes in the wall jamb and mark the wall. Only 4 of the 8 holes are using alternate sides ‘A’.

Carefully remove the panel from the tray

A

Drill 4 x 8mm holes	Fit plugs
	B
Carefully lift the panel
back into postion
Loosely fit
4 x A screws

±0mm

STEP

25

20 CFI230J

STEP

16

A

Seal behind

the wall channel

and tighten

screws

STEP

17

CFI230J 9