Samsung HB6247SX/XEO manual General, Safety Precaution, Installation Instructions

ENGLISHGB

GENERAL

Carefully read the following important information regarding installation safety and maintenance. Keep this information booklet accessible for further consultations.

The appliance has been designed for use in the ducting ver- sion (air exhaust to the outside), filtering version (air circula- tion on the inside ) or with external motor .

SAFETY PRECAUTION

1.Take care when the cooker hood is operating simultaneou- sly with an open fireplace or burner that depend on the air in the environment and are supplied by other than electrical energy, as the cooker hood removes the air from the environ- ment which a burner or fireplace need for combustion. The negative pressure in the environment must not exceed 4Pa (4x10 -5bar). Provide adequate ventilation in the environment for a safe operation of the cooker hood.

Follow the local laws applicable for external air evacuation.

Before connecting the model to the electricity network:

-control the data plate (positioned inside the appliance) to ascertain that the voltage and power correspond to the network and the socket is suitable. If in doubt ask a qualified electrician.

-If the power supply cable is damaged, it must be replaced with another cable or a special assembly, which may be ob- tained direct from the manufacturer or from the Technical Assistance Centre.

-This device must be connected to the supply network through either a plug fused 3A or hardwired to a 2 fase spur protected by 3A fuse.

2. Warning !

In certain circumstances electrical appliances may be a danger hazard.

A)Do not check the status of the filters while the cooker hood is operating

B)Do not touch bulbs or adjacent areas, during or straight after prolonged use of the lighting installation.

C)Flambè cooking is prohibited underneath the cooker hood

D)Avoid free flame, as it is damaging for the filters and a fire hazard

E)Constantly check food frying to avoid that the overheated oil may become a fire hazard

F)Disconnect the electrical plug prior to any maintenance.

G)This appliance is not intended for use by young children or infirm persons without supervision

H)Young children should be supervised to ensure they do not play with the appliance

I)There shall be adequate ventilation of the room when the rangehood is used at the same time as appliances burning gas or other fuels

L)There is a risk of fire if cleaning is not carried out in accordance with the instructions

This appliance conforms to the European Directive EC/2002/96, Waste Electrical and Electronic Equipment (WEEE). By making sure that this appliance is disposed of in a suitable manner,

the user is helping to prevent potential damage to the environment or to public health.

The symbol on the product or on the accompanying paperwork indicates that the appliance should not be treated as domestic waste, but should be delivered to a suitable electric and electronic appliance recycling collection point. Follow local guidelines when disposing of waste. For more information on the treatment, re-use and recycling of this product, please contact your local authority, domestic waste collection service or the shop where the appliance was purchased.

INSTALLATION INSTRUCTIONS

Assembly and electrical connections must be carried out by specialised personnel.

• Electric Connection

The appliance has been manufactured as a class II, therefore no earth cable is necessary.

The plug must be easily accessible after the installation of the appliance.

If the appliance is equipped with power cord without plug, a suitably dimensioned omnipolar switch with 3 mm minimum opening between contacts must be fitted between the appliance and the electricity supply in compliance with the load and current regulations.

The connection to the mains is carried out as follows: BROWN = L line

BLUE = N neutral

•The minimum distance between the support surfaces of the cooking pots on the cooker top and the lowest part of the cooker hood must be at least 65 cm.

If a connection tube composed of two parts is used, the upper part must be placed outside the lower part.

Do not connect the cooker hood exhaust to the same conduc- tor used to circulate hot air or for evacuating fumes from other appliances generated by other than an electrical source.

Before proceeding with the assembly operations, remove the anti-grease filter(s) (Fig.5) so that the unit is easier to handle.

-In the case of assembly of the appliance in the suction version prepare the hole for evacuation of the air.

•We recommend the use of an air exhaust tube which has the same diameter as the air exhaust outlet hole. If a pipe with a smaller diameter is used, the efficiency of the product may be reduced and its operation may become noisier.

•Installation

The following instruction should be followed to carry out the correct installation of the cooker hood.

1)Mounting of the cooker hood on the lower side of the cupboard.

2)Selection of the version (extraction or filtration)

•Fixing the hood to the lower part of the wall cabinet This type of appliance must be fitted inside a cabinet or inside another type of support structure.To fix it in place, use 4 screws A which are suitable for the type of cabinet, making holes

- 18 -