in accordance with the diagram shown in (fig. 1). To fit the appliance correctly, align the front panel of the cooker hood with the cabinet door and adjust spacer L using screws P (fig. 2), then ensure the appliance meets the cabinet at the rear.
• Extraction through an outside wall
The appliance expels the fumes through an outside wallor a duct. It is necessary to buy a telescopic pipe inaccordance with the standards in use (inflammable) andconnect it to flange B (Fig 3).
•Recirculation
To transform the cooker hood from the extraction version to the re circulating one ask your supplier for an activated carbon filter.
The filter must be fitted to the extracting group cooker hood in the centre of the fan grille by twisting it by 90 degrees until it is gripped securely (Fig 6). For this operation remove the
USE AND MAINTENANCE
•We recommend that the cooker hood is switched on before any food is cooked.
We also recommend that the appliance is left running for 15 minutes after the food is cooked, in order to thoroughly eliminate all contaminated air.
The effective performance of the cooker hood depends on constant maintenance; the
•The
- After a few washes, the colour of the filters may change. This does not mean they have to be replaced.
If the replacement and washing instructions are not followed, the
•The active carbon filters are used to purify the air which is released back into the room.
The filters are not washable or
The active carbon filter saturation level depends on the fre- quency with which the appliance is used, the type of cooking performed and the regularity with which the
•Clean the cooker hood frequently, both inside and outside, using a cloth which has been dampened with denatured alcohol or neutral,
•The light on the cooker hood is designed for use during cooking and not for general room illumination.
Extended use of the light reduces the average duration of the bulb.
•Replacing halogen light bulbs (Fig. 7).
To replace the halogen light bulbs B, remove the glass pane C using a lever action on the relevant cracks.
Replace the bulbs with new ones of the same type. Caution: do not touch the light bulb with bare hands.
•Commands: (pic.8) Slider the key symbols are explained below:
A= Light switch
A1 = Off key
A2 = On key
B = Speed control B1 = Off key
B2 = FIRST SPEED key
B3 = SECOND SPEED key
B4 = THIRD SPEED key
THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR EVENTUAL DAMAGES CAUSED BY BREACHING THE ABOVE WARNINGS.
- 19 -