Lightolier IS:6079 instruction sheet La OWN, IS6079, ‘Werf’’N I I

r

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE	INSTRUCTION SHEET NO.
Thisfixtureis intendedforinstallationinaccordancewiththe NationalElectrical Code and load regulations.	IS:6079
To assure full compliancewithlocalcodesandregulations,checkwithyourlocalelectricalinspectorbefore
installation. Toprevent electrical shock, turnoff electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.	0493	Page 1 of 2

INSTALLATION FOR AITACHING EXTENSION WAND SLOPED CEILINGS ADAPTER

TO LYTESPAN TRACK. FOR USE WITH LYTESPAN” TRACK SYSTEMS ONLY

Extensionwandslopedceilingadaptercan be mountedon any Basic,Advent Multipointor MonopointTrackon tailings from 0° to 90° (vertical).

Notfor usewith Lytespota with attachmentfitting 7589.

1.Grasp TOP FITTING at top of ADAPTER and insert it into the LYTESPAN TRACK. The LOCKING LEVER must be on the same side of the track as the BEAD. (see Fig. 1.)

2.Rotate the TOP FI’ITING W’ clockwise, (See Fig. 2), untilLOCKING LEVER snaps and locks in plats. (See Fig. 3.) Do not rotate adapter from LOWER FllllNG.

3.Loosen KNOB and set the lower haff of the ADAPTER to a vertical positionand tighten KNOB. (Fig, 4)

4.To Remove Depress LOCKING LEVER; then rotate TOP FllllNG 90° counter-dockwke. Do not rotate wand from LOWER FITTING,

LOCKING		LVTESPAN			!l-		NG
		c
		TRACK
BEAD		FITTING			riFIG. 3	L
LEVER				-u		‘“WERF’”’NI I I
		CLOCKWISE
FIG. 1				FIG. 2			FIG. 4
INSTRUCTIONS FOR CONVERTING FITTING TO OPERATE ON							BRASS CONTACT
2 CIRCUIT TRACK SYSTEMS
See Fig. 5, BRASS CONTACT can be raisedor lowered,Brokenlineindicatespositionfor 1 circuit
track or lower circuitof 2 circuittrack system.			-				L::;;:G
BEAD		R/la“OWN
To mnverf attachment FllTING for upper circuitof 2 circJJittrack, raise BRASS CONTACT to high
positionby Ming CONTACT as high as stop f.wrnits and CONTACT clicks into place.							FIG. 5
INSTRUCTIONS FOR AllACHING EXTENSION WAND TO EXTENSION WAND SLOPED CEILING ADAPTER
1. Insert the WAND FllllNG		into the LOWER FllllNG.
The LOCKING LEVER must be on the same side as the bead located at the bottom of the LOWER FllTING (See Fig. 6.) Rotate the WAND FllllNG
90° clockwise until LOCKING LEVER snaps and locks in place. (See Fig. 6,7, & 8).
2, To remove, depress LOCKING LEVER and rotate FllllNG 90° counterclockwise.
	$					i
		BRASSCONTACT
LOCKING_		WAND		CLOCKWISE
LEVER		FllTNG
		1
		FIG. 6		FIG. 7			FIG. 8