Samsung NV70F7786HS/EU Installation, Safety instructions for the installation, Inst allation

installation

Safety instructions for the installation

This oven may be installed only by an approved electrician. The installer is responsible for connecting the appliance to the main supply, while observing the relevant safety regulations.

•Ensure protection from live parts when installing the oven.

Power connection

If the appliance is not connected to the mains with a plug, a multi-pole isolator switch (with at least 3 mm contact

spacing) must be provided in order to satisfy safety regulations. The power
cable (H05 RR-F or H05 VV-F, min., 2.5 mm²) must be of sufficient length to be
connected to the oven, even if the oven stands on the floor in front of its built-in
cabinet. Open the rear connection cover of the oven with a screwdriver and
loosen the screws of the cable clamp before you connect the power lines to the
relevant connection terminals. The oven is earthed via the (	)-terminal. The
yellow and green cable(earth connection) must be connected first and be longer		BROWN	BLUE or	YELLOW
than the others. If the oven is connected to the mains with a plug, this plug must
		or BLACK	WHITE	and GREEN
remain accessible after the oven is installed. Samsung will take no responsibility

for accidents that originate from a missing or faulty earth connection.

WARNING: Do not allow the connecting cable to become trapped during installation, and prevent it coming into contact with hot parts of the oven.

Installation in the cabinet

With built-in furniture, plastic surfaces and adhesive for the oven should be resistant to 90 °C inside of the furniture and to 75 °C for adjacent furniture. Samsung will take no responsibility for damage of plastic surfaces or adhesive from the heat.

There should be a ventilation gap in the base of the kitchen cabinet where the oven is to be placed. For ventilation, a gap of about 50mm should be left between the lower shelf and the supporting wall. If the oven is to be installed below a hob, the hob’s installation instructions should be followed.

inst allation

	Min.550	Min.560
		Min.50
370	560
Max.50		Min.590 ~ Max.600
595	572 550
595	545
	21
		Min.460 x Min.50
Built-in

		Min.550	Min.560
370	175
		560
85
595			Min.600
		572 550
502
595		545	Min.460 x Min.50
490			Built-under
		21
			Built-in + Built-under

0

Push the appliance completely into the cabinet and fix the oven firmly on both sides using 2 screws. Make sure that a gap of at least 5mm should be left between the appliance and the adjacent cabinet.

After installation, remove the vinyl protective film, tape, paper and accessories from the door and inside of oven. Before uninstalling the oven from the furniture, disconnect the oven from the power supply and release the 2 screws on the both sides of the oven.

WARNING: The built-in furniture must have a minimum ventilation gap for Air-flow as shown on picture. Do not cover this hole with strips of wood, for this is used to provide ventilation.

The front exterior of the oven such as handle is different model by model. But the size of the oven in the picture is same.

ENGLISH - 7

NV70F7786HS-EU_DG68-00522A _EN.indd 7

2014-03-05 �� 6:59:19