Installing the Remote Control Holder on the Wall
The remote control is supplied with a plastic holder that can be fitted to the wall to hold the remote control when you are not using it.
To attach the holder to the wall, proceed as follows.
1With a pencil, mark the positions of the two holes on the wall where the
holder is to be installed.
2Drill the two holes and insert plugs as required for the type of wall on
which the holder is being installed.
3 Screw the holder into position.
Result: | You can now slide the remote control in and out of the |
| holder as required. |
|
|
Inserting the Remote Control Batteries
You must insert or replace the remote control batteries when:
◆You purchase the air conditioner
◆The remote control does not work correctly
Note | Use two LR03 1.5 V batteries. Do not use old batteries or |
| different kinds of batteries together. Batteries may be |
| completely discharged after 12 months, even if they have |
| not actually been used. |
1Slide the remote control out of its holder.
2Push the battery cover on the rear of the remote control with your thumb in the direction of the arrow and remove it.
3Insert the two batteries, taking care to respect the polarities:
◆ + on the battery with + on the remote control ◆ - on the battery with - on the remote control
4Close the cover by sliding it back until it clicks into place.