Lightolier IS:1102P1 CUT Opening FIG. a, Wire-In Fig. B, PUT Through FIG. C, Anchor FIG. D

INSTRUCTION SHEET NO.

IS:1102P1

A0403 Page 2 of 2

INSTALLATION PROCEDURE FOR FRAME-IN KITS

1002P1 & 1102P1 EXISTING CONSTRUCTION

FIG. A	FIG. B	FIG. C	FIG. D	FIG. E	FIG. F
1. CUT-OPEN	2. WIRE-IN	3. PUT THRU	4. ANCHOR	5. SNAP-ON	6. PUSH-UP

1.CUT OPENING (FIG. A)

Use MOUNTING FRAME opening as template.

2.WIRE-IN (FIG. B)

Wire to supply leads. (Use built-In Cable Clamp in J-Box for non- metallic sheathed cable (Romex) or armored cable (BX)).

3.PUT THROUGH (FIG. C)

a.Remove ADJUSTABLE MOUNTING BARS.

b.Break off BRIDGE on MOUNTING FRAME as shown in FIG. G (break WEBS on SLOTS with cutting plier).

c.Pass MOUNTING FRAME into CEILING as shown.

4.ANCHOR (FIG. D)

a.Using NAIL CLIPS, (order separately; Cat. #1985N for 1002 Frame-In Kit, Cat. #1985S for 1102 Frame-In Kit).

5.SNAP-ON (FIG. E) SEE SEPARATE REFLECTOR TRIM

6.PUSH-UP (FIG. F) INSTRUCTION SHEETS.

WARNING-USE ONLY REFLECTOR TRIMS PROVIDED BY LIGHTOLIER INC. USE OF OTHER MANUFACTUR- ERS’ REFLECTOR TRIMS VOIDS THE UNDERWRITERS LABORATORIES LISTING AND COULD CONSTITUTE A FIRE HAZARD.

® LIGHTOLIER a GENLYTE THOMAS company.

631 Airport Road, Fall River, MA 02720