Samsung RSH7UNBP1/XEO, RSH7ZNRS1/EUR Reattaching the Fridge Door, Reattaching the Front Leg Cover

Reattaching the Fridge Door	Reattaching the Water Supply Line
1. Insert the lower hinge 1 back into the lower	1. Insert the water line 2 into the coupler 1 .
hinge bracket 2 .

1

2

2.Fit the hole in the corner of the fridge door 3 over the lower hinge 4 .

3

4

3.Insert the upper hinge shaft 5 into the hole on the hinge 6 . Make sure the hinge is level between the upper hinge hole 7 and the hole on the top of the cabinet 8 . Then, reattach hinge screws 9 and the ground screw 10 by turning it in a clock wise direction.

4. Place the front part of the upper hinge cover 11 on the front of the upper hinge 12 and reattach it with the screw.

12

11

1

2

2.The Water Line must be fully Inserted to the center of transparent coupler to prevent water leakage from the dispenser.

3.Insert the 2 clips in the install pack and check that each clip holds the line fi rmly.

Center of transparent

coupler

clip A (1/4”) (6.35mm)

Do not cut the water line. Gently separate it from the coupler.

Reattaching the Front Leg Cover

Before attaching the cover, check water connector for leakage.

Replace the front leg cover by turning the three screws clockwise, as shown in the fi gure.

10_ setting up