Samsung RSH7ZNRS1/XEG Connect the water line to the refrigerator, Secure the water line, Squashed

Connect the water line to the refrigerator.

-Remove the compressor cover of the refrigerator.

-Connect the water line to the valve, as shown in the fi gure.

-When connected, check if there is any leakage. If any, repeat the connection.

-Reattach the compressor cover of the refrigerator.

WATER LINE

CONNECTION NUT

INSTRUCTIONS

COMPRESSOR COVER OF

REFRIGERATOR

Secure the water line.

-Using clip ”A”, fi x the water line to the wall (the back of

refrigerator).	CLIP A
- When the water line is
secure, make sure whether
the water line is not	WATER LINE
excessively bent, pinched or
squashed.

Removing any residual matter inside the water supply line after installing filter.

1.Turn ON the main water supply & turn OFF the valve to the water supply line.

2.Run water through the dispenser until the water runs clear (approx. 1L). This will clean the water supply system and remove air from the lines.

3.Additional fl ushing may be required in some households.

4.Open the refrigerator door and make sure there are no water leaks coming from the water fi lter.

A newly installed water fi lter cartridge may cause water to briefl y spurt from the water dispenser. This is due to air getting into the line. It should pose no problem to operation.

01 SETTING UP

setting up _15