Samsung RSE8KPPS1/XEP manual Checking the Parts, Connecting to water supply line

Page 28

CHECKING THE WATER DISPENSER LINE (OPTIONAL)

1)In order to operate the ice maker properly, water pressure of 1.4 ~ 10 kgf/cm2 (0.14 ~ 9.8Mpa, 19.9 ~ 142.2 psi, 1.37 ~ 9.8 bars) is required.

In this range a 100 cc paper cup can be filled in 10 seconds.

2)The water filter removes particles. It does not sterilize or destroy any micro-organisms.

3)If the refrigerator is installed in an area with low water pressure (below 1.4kgf/cm2 (0.14 Mpa, 19.9 psi,1.37bars)), you should install a booster pump to compensate for the low pressure.

4)Ensure the water storage tank inside the refrigerator is properly filled initially. Push the water dis penser lever until the water runs from the outlet.

 

A universal water supply kit is available at extra cost from your dealer. The refrigerator manufacturer

NOTE

recommends using a water supply kit containing copper tubing.

 

Checking the Parts

Purifier

Water line

Valve water fitting

Sealing tape

Tapping screw x 12EA

Clip A x 12EA

(Connector Water Filter Assy)

INSTALLING OF THE WATER DISPENSER LINE

(Case 1)

Connecting to water supply line

1.

Cold Water line

 

- Shut off the main water supply line and turn the Ice

2.

Pipe Clamp.

3.Copper (or Plastic) line

maker to the off position.

4.Compression Nut

- Locate the nearest cold drinking water line.

5.Compression Sleeve

- Follow the instructions in the ice maker installation kit.

6.Shut Off Valve

 

7.Packing Nut.

28

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Side by Side Safety Instructions Safety PrecautionsHOW to Connect Electricity Grounding Caution Major Features Initial Operating ConditionControl Panel Freezer TEMP. ButtonTemperature Control Temperature settingDigital Panel Without CoolSelect Zone ModelIce Dispenser Push the ice dispenser lever with a cupWater Dispenser Cold WaterShelves and Bins RefrigeratorFood Storage Guide Tempered Glass ShelfDoor Bin Plastics DrawerChilled Food Storage in Refrigerator Soft Freeze Zero Zone 0oCQuick Cool CoolCoolSelect ZoneTM Drawer Guide Optional ThawRemoving the Freezer Accessories Beverage Station TMCleaning the Accessories Changing the Interior Light DeodorizerWater Filter Indicator light Using the dispenser without the water filterOrdering replacement filters Water FilterChecking the Dimensions of your Entrance Door Selecting the Location for the RefrigeratorRemoving the Front Leg Cover Removing the Front LEG CoverSeparating the water supply line from the refrigerator Removing the Refrigerator Doors Removing the Freezer DoorRemoving the Refrigerator Door Reattaching the Refrigerator Doors Reattaching the Freezer DoorReattaching the Refrigerator Door Reattaching the Water Tube Reattaching the Front Leg Cover OptionalPlease level the refrigerator first Doors will be uneven if the refrigerator is not levelAdjust the Clearance Between the Doors Connecting to water supply line Checking the PartsConnect the water line to the refrigerator Check the water supply lineInstall the water filter Secure the water lineCheck the amount of water supplied to the ice tray Remove any residual matter inside the water supply lineBefore YOU Call for Service Small or hollow cubes Slow ice cube freezingWorkon some models On some modelsAmbient Room Temperature Limits
Top Page Image Contents