HOW TO ADJUST THE DOOR GAP
If the gap between the left and right fridge compartment doors is not even.
• You can adjust the gap by turning the bolt at the top right of the cold storage compartment door.
• Do not turn the bolt too far. You can break it.
1.With the doors closed, remove the 3 screws holding the top cover using a Phillips screwdriver, and then lift it off together with the connected cables.
•Water line installation kits are available at extra cost from your dealer.
We recommend using a water line installation kit that contains copper tubing and 6 mm (¼”) compression nut.
•The new
Connecting to the water supply line
1.First, shut off the main water
supply.
2.Locate the nearest cold water drinking line and install the pipe clamp and shut off valve.
up 01setting
2.Turn the bolt with a 4 mm hexagonal
the gap. (Not provided)
3. Turn the bolt clockwise to (
) widen the gap.
Turn the bolt counter clockwise (
) to narrow the gap.
INSTALLING THE WATER
DISPENSER LINE
A water dispenser with a filter is one of the helpful features on your new refrigerator. To help promote better health, the water filter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You may need to purchase a water purifying system to do that.
The water line also connects to the ice maker.
For the ice maker to operate properly, water pressure of 138 ~ 862 kPa is required.
If the refrigerator is installed in an area with low water pressure (below 20 psi), you can install a booster pump to compensate for the low pressure.
After you have connected the water line, make sure the water storage tank inside the refrigerator is properly filled. To do this, press the water dispenser lever until the water runs from the water outlet.
Cold water line
Pipe clamp
Shut off valve
3.Connect the water line installation kit to the shut off valve.
Cold water line
Water line installation kit Pipe clamp 
Shut off valve 
Connecting the water supply line to the refrigerator.
There are several items that you need to purchase to complete this connection.
You may find these items sold as a kit at your local hardware store.
For Copper Tubing | For Plastic Tubing | ||
• | ¼” copper tubing | • | ¼” plastic tubing |
• ¼” compression nut (1pc) |
| → Molded end(Bulb) | |
• | Ferrule (2pc) | • | ¼” compression nut (1pc) |
|
|
|
|
setting up _21
2015. 8. 26. |
��
11:37