Lightolier 1000LV instruction sheet Install Lamp, Horizontal Adjlkwment

5.INSTALL LAMP

NOTE Socket manufacturers have auggeeted that eocket may fail after 3 to 6 relampings. If this occurs, socket can be replaced by disconnecting male connectors (attached to socket leads) from female connectors (attached to fixture leads) and replacing it with a new eocket procured through Lightolier (Fig. G).

A, Check to see that power is OFF before Iamping or relamping.

B.Remove PINHOLE FACE PLATE fmm HOUSING by inserting fingera in aperture and pull apari from HOUSING (Fig. H).

G Remove IAMP RING fmm LAMPIYOKE HOLDER by pulling straight down (Fig. l).

D. Insert correct LAMP (MR16) between LAMP SPRINGS until face of LAMP sits firmly on GLASS IAMP GUARD (Fig. J). See warninge below.

E. Attach SOCKET to hi-pin pmnga on LAMP (Fig. J).

E Insert LAMP RING with LAMP and GIASS LAMP GUARD attached back into LAMP/YOKE HOLDER (Fig. K or l).

6. VERTfCAL/ANGLE ADJUSTMENT

Insert a screwdriver into the SLOT in LEG of lAMPIYOKE HOLDER, and ueing the screwdriver as a lever, tilt the entire IAMPIYOKE HOLDER to the desired angle (Fig. K).

7.HORIZONTAL ADJLKWMENT

A.The entire LAMP/YOKE HOLDER can be horizontally rotated to aim the angle of light aa it Ieavea the hole in the APERTURE TRIM (Fig. K).

B.Graspin the YOKES on either eide of the LAMP/Y 8KE HOLDER, rotate the LAMP to the deeired angle.

NOIE LOW VOLTAGE FIXTURES should be dimmed only with special dimmers intended specifically for that purpoea Use Llghtolier Lytemode, Scenist, Crescendo VA, Neptune VA Praolslon VA, Easyaet VA, Sunrise VA, Redlent VA or equivalent produots by others or verleble

autotraneformera or eleatronlo dlmmera intended for uae with low voltege fixture% 2. fmw voltage fixtures may produce audible sound whan ua6d

with dimme~ which may be ob}eotlonsl in acoustically criticsl erea~

IS1052LV

0890

Page 2 of 2

PINHOLE

FACE PLATE

~\

FIG. H

LAMPNOKE

HOLDER

FIG. I

FIG, J

1-