Installing batteries (Battery size : AA)
1.Press the back of the remote at the very bottom with both thumbs, and then slide the battery cover up in the direction of the arrow.
2.Install two batteries so that the polarity of the batteries
3.Slide the cover down in the direction of the arrow to close the battery cover.
IR Blaster
When you connect an IR Blaster with your TV, you can control connected external devices with your TV using the Smart Touch Control.
✎✎ If you control an external device by using the Smart Touch Control, the IR Blaster sends an IR signal into a corresponding external device.
✎✎ Install the IR Blaster within 50 cm and 45 degrees of the up, down, left and right directions of the IR sensor of the external device.
Power Switch
|
| Pairing Button |
| |
| OPEN |
| Device Indicator LED | |
|
|
| ||
|
| PAIRING | IR Blaster shows the | |
ON | 1 | pairing state. | ||
| ||||
| 2 |
|
| |
OFF | 1 |
|
|
OPEN
Installing batteries (Battery size : AA)
1
1
2 | 1 |
| 2 |
| 1 |
1
OPEN OPEN
| 1 |
| 1 |
2 | 1 |
| 1 |
OPEN OPEN 
1.Hold the both sides of the battery holder and pull it out.
2.Install four batteries so that the polarity of the batteries
3.Push it back.