Samsung HT-C450N/KE manual Installing the Speakers on the Tallboy Stand, Connecting The Speakers

Installing the Speakers on the Tallboy Stand

02

*HT-C453N only - Front Speakers

*HT-C455N only - Front/Rear Speakers

1.Turn the Stand Base upside-down and connect it to the Stand.

2.Insert small screws (4*20, For connecting Stand & Stand Base) clockwise into the four holes marked using a screwdriver as shown in the illustration.

!CAUTION : When you use a torque screw- driver, be careful not to put excessive force. Otherwise, it runs idle or can be damaged. (torque screwdriver- below 15 kg.f.cm

3.Connect the upper Speaker to the assembled Stand.

4.Insert another large screw (5*15, For connecting Speaker & Stand) clockwise into the hole on the rear of the speaker using a screwdriver.

5.This is the appearance after the speaker is installed. Follow this steps to install other speaker.

Connecting The Speakers

1
	Stand
	Base
	Stand
3	Speaker

Stand

5

1. Press down the terminal tab on the back of the speaker.

2. Insert the black wire into the black terminal (–) and the red wire into the red terminal (+), and then release the tab.

3. Connect the connecting plugs to the back of the product by matching the	Black	Red
colours of the speaker plugs to the speaker jacks.

In case of HT-C450N

Centre Speaker

Front Speaker (R) Front Speaker (L)

	VIDEO
	OUT
DIGITAL	HDMI OUT
AUDIO IN
OPTICAL
	AUX IN	COM
Rear Speaker (R)	Rear Speaker (L)

Subwoofer

* Refer to page 16 for the speakers of HT-C453N/C455N.

English 1