Samsung BD-F5500/UM manual Appendix, Playing Photo Contents, Troubleshooting

4.When done, press the v button.

5.To change the play list, press the Return button to return to the Music List. Repeat Steps 2, 3, and 4.

6.To cancel the play list and return to the Home screen, press the Return or Exit button.

✎NOTES✎

`` You can create a playlist with up to 99 tracks on Audio CDs (CD-DA).

`` If you remove all the tracks from a play list and then press the v button, the player lists and plays all the tracks on the disc.

Playing Photo Contents

You can control the playback of photo content located on a Blu-ray disc, DVD, CD, USB device, or your computer.

Using the Tools Menu

During playback, press the TOOLS button.

Start Slide	Select to start the slide show.
Show
Background	Select to listen to music while
Music	viewing a slide show.
Zoom	Select to enlarge the current
	picture. (Enlarge up to 4 times)
Rotate	Select to rotate the picture. (This
	will rotate the picture either
	clockwise or counter clockwise.)
Information	Shows the picture information.

✎✎ NOTES

`` Depending on the disc or storage device, the Tools menu may differ.

`` To enable the background music function, the photo file must be in the same storage media as the music file.

However, the sound quality can be affected by the bit rate of the MP3 file, the size of the photo, and the encoding method.

`` You can't enlarge the subtitle and PG graphic in the full screen mode.

Appendix

	Troubleshooting
Before requesting service, please try the following solutions.
PROBLEM	SOLUTION
No operation can be	• Check the batteries in the remote control. They may need replacing.
performed with the remote	• Operate the remote control at a distance of no more than 6.1m from the
control.	player.
	• Remove batteries and hold down one or more buttons for several minutes
	to drain the microprocessor inside the remote control to reset it. Reinstall
	batteries and try to operate the remote control again.
	• Press the @ button (on front panel) for more than 5 seconds with no disc
	inside. All settings will revert to the factory settings.
	• Press the Pbutton (on front panel) for more than 5 seconds.
Disc does not play.	• Ensure that the disc is installed with the label side facing up.
	• Check the region number of the Blu-ray Disc/DVD.
Disc Menu does not appear.	• Ensure that the disc has disc menus.
The prohibition message	• This message appears when an invalid button is pressed.
appears on the screen.	• The Blu-ray Disc/DVD’s software doesn’t support the feature (e.g., angles).
	• You’ve requested a title or chapter number or search time that is out of
	range.
Play mode differs from the	• Some of the functions selected in the Setup Menu may not work properly if
Setup Menu selection.	the disc is not encoded with the corresponding function.
The screen ratio cannot be	• The Screen Ratio is fixed on your Blu-ray Disc/DVD.
changed.	• This is not a problem with the player.
No audio.	• Make sure you have selected the correct Digital Output in the Audio Options
	Menu.

18