Therma-Tru Light Commercial Doors and Frames manual Door Handing Chart, General, Single Doors

Therma-Tru®Light Commercial/Multi-Family - Doors and Frames

	•	Material shown on these drawings will be
		fabricated only after formal approval by the
		architect, receipt of approval hardware schedule,
		and all necessary hardware templates.
	• All frames shall be shipped “knocked-down”
		unless otherwise specified.
	• All frames and doors shall be chemically washed,
		rinsed, and dried prior to receiving one coat of
		paint.
NOTES	•	Doors and frames will be reinforced for surface
		mounted hardware as required. Drilling and
		tapping for surface mounted hardware shall be
		applied by others.

DOOR HANDING CHART

SINGLE DOORS

OUTSIDE	OUTSIDE
LEFT HAND INSWING	RIGHT HAND INSWING

OUTSIDE	OUTSIDE
LEFT HAND REVERSE/	RIGHT HAND REVERSE/
RIGHT HAND OUTSWING	LEFT HAND OUTSWING

PAIRS OF DOORS

•	All standard type hardware will be located at this
	manufacturer’s standard locations as shown on
	the door and frame elevations. Hardware items
	such as panic exit devices, deadbolts, etc. will also
	be located at manufacturer’s standard locations
	unless specifically advised.
•	Installations of all glass and glazing to be
	performed by others.
•	Doors, frames, and finished hardware to be
	installed by others.
•	Anchor bolts and expansion shields for any type
	fastener to be furnished by others.

GENERAL	•	It will be the responsibility of the General
		Contractor to coordinate hardware locations.
	•	All frames will be supplied with the required wall
		and floor anchors as illustrated on the frame detail
		sheet.
	• All frames and doors wll be tagged with shop
		marks. This schedule can be used to cross

OUTSIDE

LEFT HAND ACTIVE

OUTSIDE

LEFT HAND REVERSE ACTIVE/

RIGHT HAND OUTSWING ACTIVE

OUTSIDE

RIGHT HAND ACTIVE

OUTSIDE

RIGHT HAND REVERSE ACTIVE/ LEFT HAND OUTSWING ACTIVE

• All frames must be set absolutely plumb, square,

and level.

• All frames will be supplied with rubber door silencers: three for single swing openings and two per header for double swing openings.

	reference shop marks with architects marks.
•	These drawings are not intended for use by other
	trades.
•	Field welding, grinding, finishing, and attachment
	of field splices by others.

JOB NUMBER:

PROJECT:

LOCATION:

ARCHITECT:

CONTRACTOR:

FINISHED HARDWARE BY:

SHEET NUMBER: OF

RECORD OF SUBMITTALS

SUBMITTEDRETURNED

1st

2nd

3rd

4th

RECORDED APPROVED DRAWINGS

RECORDED APPROVED HARDWARE

DRAWN BY: