Water Supply Connector Filter

Waterdrop mark	Cause	How to level

	The front part is	Level it by adjustable legs.
	lower	Level it by adjustable legs.
	lower

	The back part is	Adjust the height by using the adjustable rubber
	lower	or prop at the back.

	The left part is	Adjust the left part by using the adjustable legs
	lower	at the front and the adjustable rubber at the back.
	lower

	The right part is	Adjust the right part of the washer by using the adjustable leg
	The right part is	at the front and the adjustable rubber at the back.
	lower	at the front and the adjustable rubber at the back.
	lower

1.Pull out the filter and wash well.

inlet water valve

2.Pull in the filter and connect the hose to the inlet water valve tightly.

3.Check if there is a leakage. Note to tighten up the connector.

HOW TO PUT THE DETERGENT IN AND ADD THE FABRIC SOFTENER

1.Open the detergent box by pulling in the direction of the arrow as shown in the

figure and then put the powder detergent in the detergent box.
2. Put in one-time amount of detergent evenly so the detergent	may not brim over the box.
Detergent Device	Softener Device
Put the detergent
in proportion to
water level
Softener Device
Softener
baseline

•When a proper amount (one time does) of fabric softener is stored in the softener inlet,it is automatically put in at the last rinsing cycle.

•Do not use detergent, bleach or starch into the Softener Inlet.

•Using too much softener may produce unsatisfactory results.

•Do not open the lid during the Spin Dry cycle.

If added too early, its effectiveness will decrease.

•Do not leave the softener into the Softener Dispenser for a long time. Because softner became stiff.

CAUTION : If softener is stored over the above base line, it may flow down at any time.