Samsung WA13G2Q1FW/YL, WA13G2Q1IW/YAJ Connecting the Water Supply Hose, Next,take the adaptor

CONNECTING THE WATER SUPPLY HOSE

1.Remove the adaptor from the water supply hose.

5. Connect the other end of the water supply hose to the inlet water valve at the back of the washer.

Screw the hose clockwise all the way in.

2.First,using a "+" type screw driver, loosen the four screws on the adaptor.

Next,take the adaptor and

turn part(b) following the arrow for gap about 5mm between them.

a

b

5-1.Connect the other end of the water supply hose to the inlet water valve at the top of the washer.

Screw the hose clockwise all the way in.

3.Connect adaptor to the water tap by tightening the screws firmly.

Then, turn part (b) following the arrow and put (a) and (b)together.

a

b

If the water tap is a screw type,assemble a water supply hose that fits to the tap as shown.

4. Connect the water supply

hose to the adaptor. Pull down the part (c) of the water supply hose .When the part (c)is released,

the hose is automatically c connected to the adaptor making a 'click' sound.

NOTICE After completing connection, if water leaks from the hose, then repeat the same steps.

Use the most conventional type of faucet for water supply. In case the faucet is square or too big,remove the spacing ring before inserting the faucet into the adaptor.

LEVELLING ● If the washer is not leveled with the ground, it makes the machine tremble more or be out of order. So, make sure that the washer is leveled properly.

●Adjust the height control legs to make eve.

Lock

Lock Nut

UNLOCK LOCK

Adjustable

Leg

Unlock

●After slightly lifting up the machine, rotate the adjustable leg counter-clockwise and pull as much as need to adjust the reight.

●After putting down the machine after adjustment.

UNLOCK LOCK

UNLOCK LOCK Lock Unlock

●Adjust the height and secure.

●Secure the lock nut by rotating it firmly.

●If the lock nut is not secured, the adjustable leg may be released.

Adjustment of height

If not leveled, adjust the legs to level the washer.

●Be careful not to put in your hand under the legs. (It may cause some injury)

Pull the handles located at the right and left of the front side and slide off.

Adjust the water drop mark to be in the red circle pulling back the machine slightly, and then, push it with a feet to fix.

Fix the handles by hand completely.

8