WASHINGPROCEDURE
TO WASH
1.Before starting washing, check the following;
-Connect the water supply hose and open the water tap.
-Connect the power cord to the power supply outlet.
-Lay the drain hose(A) down toward a sinkhole.
(WITHOUT PUMP)
-Place the drain hose(A) in sink or bath about 70~80cm above the ground.
70~80cm | (WITH PUMP) |
2.Set the WASH SELECTOR KNOB to the desired mode.
3.Set the CYCLE SELECTOR KNOB to ‘WASH·RINSE’. (In case no drain pump) (‘WASH’ in case drain pump)
(Without pump) | (With pump) |
4. Set the WATER SELECTOR KNOB to WASH .
5. Load laundry in the wash tub.
6. Fill water in the wash tub and add the detergent.
7. Set the WASH TIMER
8. After washing,set the CYCLE SELECTOR KNOB to ‘DRAIN’ for drain.
SPIN DRY
1.Transfer the clothes into the spin basket and arrange the clothes evenly.
Bottom of balancer
Safety cover
2.Be sure to attach the safety cover and close the inner lid.
inner lid
safety cover
4
3. Close the spin dryer lid.
4.Set the AIR TURBO SPIN TIMER
5.Incomplete spining. (Severe vibration or unbalance) See “When you load ...”on page 6.