RINSING
1.Set the CYCLE SELECTOR KNOB to ‘WASH RINSE’. (In case no drain pump) (‘WASH’ in case drain pump)
(Without pump) | (With pump) |
2.Supply the proper amount of water as not to overflow the top of the washing tub.
3.Set the WASH TIMER 2~3minutes.
4.Drain the water. Set the CYCLE SELECTOR KNOB to ‘DRAIN’
5.Repeat this cycle until drain water is clean. (2~3 cycles)
6.In case no drain pump.
- Be sure lay the drain hose down.
In case drain pump.
- Be sure place the drain hose in sink or bath.
OVER FLOW RINSE
1. Keep suppling water
Adjust water pressure to ensure that the amount of water supplied does not exceed that water drained.
3.As soon as the WASH TIMER shuts off, turn off the water tap.
|
| 4. Set the CYCLE SELECTOR |
(Without pump) | (With pump) | KNOB to ‘DRAIN’. |
|
2. Set the WASH TIMER 6~8 minutes.
ADDITIONAL RINSE
After rinsing you can select this course for more effective rinse (Don’t select only this course for rinse.)
1 Load the laundry evenly into the | inner lid |
| |
spin basket. |
|
| safety cover |
4After stopping water supply, cover the laundry with safety cover and close the inner lid.
2 Set the WATER SELECTOR | (b) | 5 Close the spin dryer lid. |
(a) | ||
KNOB to SPIN (a) and |
|
|
CYCLE SELECTOR KNOB |
|
|
to ‘DRAIN’(b). |
|
|
3 Supply water for about 1 | 1min. | 6 Set the AIR TURBO SPIN |
minute. Adjust the water | TIMER 2~3 minutes. | |
flow to prevent overflow |
|
|
from the wash tub. |
|
|
|
| 5 |