INSTALLATION
ENVIRONMENT
Leave some space
Space at last 15cm between the washer and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak surface, noise or vibration may be occured. (Allowable is 2˚)
CHANGING THE POSITION OF THE DRAIN HOSE
Before attempting to change the position of the drain hose, disconnect the plug from the outlet.
1. Route the drain hose inside the machine.
2.Take out the drain hose from the opposite hole and insert the drain hose into the hose holder.
LAUNDRY GUIDE
AMOUNT OF CLOTHES
Water Level | Low | Middle | High |
|
|
|
|
Shirts(Synthetics) | 22 Pieces | 29 Pieces | 35 Pieces |
|
|
|
|
Under Shirts(Cotton) | 38 Pieces | 48 Pieces | 58 Pieces |
|
|
|
|
Working clothes(Cotton) | 16 Pieces | 20 Pieces | 25 Pieces |
|
|
|
|
Never install the washer near water.
Do not place the washer in steamy rooms or where the washer is directly exposed to rain. Moisture may destroy the electrical insulation and cause an electrical shock hazard.
Avoid direct sunlight or heating devices.
As plastic and electrical components are
2 
1
Hose holder
DETERGENT
AMOUNT OF | WATER |
DETERGENT | LEVEL |
44g | Low(44l) |
|
|
56g | Middle(56l) |
|
|
67g | High(67l) |
|
|
SPIN DRY TIME
TIME | TYPE OF LAUNDRY |
1min. | Thin(synthetic fiber) |
1~2min. | wool |
3~5min. | cotton |
5min. | thick(cotton) |
affected by direct heat, never place the washer near heaters, boilers,etc.
Do not place under direct sunlight.
Install the drain hose about 70~80cm above the ground
HOW TO CLEAN THE FILTER (In case drain pump)
1.Place a rag under the washer filter not to wet the floor.
2.Rotate the filter counterclockwise and pull out the filter.
3. Remove dirts and rotate | Filter |
Follow the instruction detergent printed on the package for amount of detergent.
MAINTENANCE
for pump model. | 70~80cm |
|
the filter clockwise until it |
|
|
locks in position. | Open | Close |
|
| Rag |
WHEN YOU LOAD THE LAUNDRY INTO THE SPIN BASKET.
Press the laundry evenly and put the safety cover into the spin basket drum as shown in the figure.
TO PICK OUT THE CLOTHING WHICH HAS FALLEN BETWEEN THE BASKET AND TUB.
For safty, pull the power supply plug out of the socket.
1.Disassemble two screws from the spin dryer hatch. 2.Pull up the spin dryer hatch to remove it. 3.Remove the clothing. 
4.Close the spin dryer hatch.
CLEANING THE MACHINE 
1. OVERFLOW FILTER
Pull the upper side of the overflow filter with
your fingers into the holes in the direction of arrow as shown in the figure.
3. CLEANING THE WASHER BODY
2. CLEANING THE FILTER
Pull the overflow filter out and take up the filter by removing 3 screws as shown in figure. Wash the filter and washing tub.
TROUBLE SHOOTING
TROUBLE | CHECK POINT | TROUBLE | CHECK POINT |
|
|
|
|
|
|
| Is the filter clogged |
The washer | Check that the power cord is | Incomplete | with lint? |
does not work. | connected to a power outlet well. | draining | ● See “Cleaning the |
| Power stoppage? |
| machine” on page 7. |
|
|
|
|
|
|
| Is the spin dryer lid closed |
Wipe off strains on the cabinet and operation panel with soft cloth.
Do not use benzene,thinners,cleanser,or wax, nor scrub the washer with a brush. Painted surfaces or plastic parts will be damaged.
Clothes will |
|
| completely? |
not move freely. Is the laundry overloaded? | The spin dryer | Are laundry(socks,etc.)falling | |
|
| basket will not out of the spin dryer basket and | |
|
| run. | clinging to the axle? |
Incomplete |
| ||
Are the laundry arranged evenly? |
| ● See “To pick out...” on | |
spinning |
| page 8. | |
|
| ||
7 | 8 |