Samsung SWT50B1EWS/XSG, SWT50B1IW/YFE, SWT50B1NW/YL manual Description and / Cleaning of Parts

DESCRIPTION AND / CLEANING OF PARTS

.

CLEANING THE FILTER

•Pull the overflow filter out and take up

INNER LID

DRAIN HOSE

(with pump)

OVERFLOW

FILTER

LINT FILTER This is used for gathering the dregs made during washing.

WASH TUB LID

Be sure to keep the lid closed during washing and spinning.

PULSATOR

OVERFLOW FILTER	CLEANING THE LINT FILTER
• Pull the upper side of the	• If the dregs are piled up in the
overflow filter with your	lint filter after finishing the wash,
fingers into the holes	push down and
in the direction of	pull it out as
arrow as shown	shown in the
in the figure.	figure.
	• Wash the filter
	net in water.

SPIN DRYER LID When you open this

lid while the spin basket is spinning,the spinning will be stopped by the brake system.

SPIN DRYER BASKET

POWER CORD The plug’s shape

may not be similar to that shown in this drawing.

WATER DRAIN HOSE

(without pump)

EARTH WIRE

WASH TUB

DRAIN FILTER

OVERFLOW FILTER

Pull the upper side of the A overflow filter with

two fingers inserted into hole ‘A’ in the direction of arrow

as shown in the figure.

the filter by removing 3 screws as shown in figure. Wash the filter and washing tub.

•Push the strainer(filter) out and take

up the filter as shown in figure. Wash the filter and washing tub.

DRAIN FILTER

In case of incomplete drain, disassemble the drain filter with screw driver(+), and remove lints from the filter as shown in the filter as shown in

the figure.

HOW TO CLEAN THE FILTER (In case drain pump)

1.Place a rag under the washer filter not to wet the floor.

2.Rotate the filter counterclockwise and pull out the filter.

3.Remove dirts and

rotate the filter clockwise until it locks in position.

CLEANING THE WASH TUB

First, fill water in the wash tub to ‘L’ level(, then drain water from the wash tub simultaneously with operating wash cycle for 1~2 minutes. • Close the wash tub lid.

2