Samsung SWT50B1EW/YKH, SWT50B1IW/YFE, SWT50B1NW/YL, SWT50B1IW/YAJ Installation, Additional Rinse

Bottom face of

main body

3

SPIN DRY TIMER

WATER SELECTOR

ADDITIONAL RINSE

1After rinsing you can select this course for more effective rinse

(Don't just select this course for rinse.) Load the laundry evenly into the spin basket.

2 Set the WATER SELECTOR KNOB to SPIN and

Wash Spin

CYCLE SELECTOR

KNOB to ‘DRAIN’.

3 Supply water for about 1 minute. Adjust the water flow to prevent overflow from the wash tub.

4	After completing the water supply,
	cover the laundry with		inner lid
	safety cover and close		safety
	the inner lid.		cover
5	Close the spin dryer	lid.
6	Set the SPIN DRY		0
		5	1
	TIMER 2~3 minutes.
		4	2

INSTALLATION

LOCATION

Leave some space of

at least 15cm between the washing machine and the wall.

Place the washing machine on a sturdy flat surface.

If the washing machine is placed on an uneven or weak surface, noise or vibration may occur. (Allowable is 2˚)

Never install the washing machine near water. Do not place the washing machine in steamy rooms or where the washing machine is directly exposed to rain. Moisture may damage electrical insulation and cause an electrical shock to occur.

Avoid direct sunlight or heating devices. As plastic and electrical components are

affected by direct heat, never place the washing machine near heaters, boilers, etc., or under direct sunlight.

Install the drain hose	70~80cm
about 70~80cm above
the ground for pump model.

MOUNTING THE LEGS

Lay down the washer with its back facing downward. Insert four legs into the leg mounting

sections of the base corners of the main body.

Insert the claw of the	Claw
leg with the square	Square
hole of the leg	hole
	2
mounting section,	1
and push the leg in
the arrow direction

as shown in the Leg figure until it clicks.

CHANGING THE POSITION OF THE DRAIN HOSE

Before attempting to change the position of the drain hose, disconnect the plug from the outlet.

1.Route the drain hose inside the machine. 2.Take out the drain hose from the opposite hole

and insert the drain hose into the hose holder.

2 1

Hose holder

CONNECTING THE DRAIN HOSE

After attaching the connector ring(a), insert the drain hose(b) in the draining direction.

a

b

CONNECTING THE DRAIN HOSE

1. Before connecting the drain hose, remove the cover (a) from the drain hole.

2.After pressing the joint ring (b), insert the drain hose(c) to drain direction.

(a)

(C) (C)

(b)(b)

(In case of pump drained washer)

4