U-Line 2275DWRCOL, 2275DWRW, 2275DWRCS Custom 1/4 Drawer Panel Inserts, Full Overlay Drawer Panels

8 Drawer Panel Installation

Custom 1/4" Drawer Panel Inserts

Drawer Panel Preparation

Custom drawer panels can be inserted into the drawer fronts. Custom drawer panels can be flat or raised, as long as the maximum panel thickness where inserted into the drawer front reveal (channel) is 1/4"-thick. For raised panels, the depth of the reveal is 1/4" on all four sides.

IMPORTANT

Raised panels will reduce the drawer’s front clearance if the unit is installed facing an appliance or structure (see Page 5).

Cut the panel inserts to the following dimensions. Custom 1/4" Dimensions:

Width:23-1/32"

Height:12-15/32"

The door panels must not have a total weight of more than 20 lbs.

Drawer Panel Installation

Install the insert as follows:

CAUTION

Use care when handling the insert. Insert edges may be sharp.

Full Overlay Drawer Panels

Drawer Panel Preparation

Full overlay drawer panels completely cover the drawer fronts and handles to give a built-in appearance. Overlay units are shipped ready for Full Overlay installation.

Note: For standard installations, both drawers mount the same and a 1/2" gap is achieved between drawers.

Cut the overlay to the following dimensions. Full Overlay Dimensions:

Width:23-3/4"

Height:14-3/4"

IMPORTANT

The thickness of the wood overlay panel must be 3/4". The door panel must not weigh more than 20 lbs.

Drawer Panel Installation

Removing Existing Drawer Fronts

1.Open drawer. Pull drawer gasket out of groove (top edge of drawer only). Start in the middle and pull outward, moving toward the edge (see below). This may take some force.

2.Remove and save the two screws (1) located at the ends of the handle. Remove the handle.

Handle

Screw

Gasket

1

1.Open drawer. Pull drawer gasket out of groove (top edge of drawer only). Start in the middle and pull outward, moving toward the edge . This may take some force.

2.Remove and save the two outside screws.

3.Remove the original handle and discard.

4.Remove and discard existing panel and cardboard spacer.

5.Slide custom drawer panel insert into 1/4-inch channel in drawer front.

6.Holding drawer gasket out of the way, replace handle on drawer, making sure it is seated properly on insert and that screw holes line up.

7.Install two small screws removed in Step 2.

8.Starting at the corners and working inward, push drawer gasket into place on drawer.

Handle

Screw

Gasket

Standard

Handle

Full Handle

3. Remove existing panel and cardboard spacer. Discard the spacer.

U-Line Drawer Panel Installation 8