INSTALLATION
ENVIRONMENT
Leave some space
Space at last 15cm between the washer and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak surface, noise or vibration may be occured. (Allowable is 2˚)
Never install the washer near water.
Do not place the washer in steamy rooms or where the washer is directly exposed to rain. Moisture may destroy the electrical insulation and cause an electrical shock hazard.
Avoid direct sunlight or heating devices.
As plastic and electrical components are affected by direct heat, never place the washer near heaters, boilers,etc.
Do not place under direct sunlight.
Install the drain hose about 70~80cm above the ground for pump model.
HOW TO CLEAN THE FILTER (In case drain pump)
1.Place a rag under the washer filter not to wet the floor.
2.Rotate the filter counterclockwise and pull out the filter.
3.Remove dirts and rotate
the filter clockwise until it locks in position.
CONNECTING THE DRAIN HOSE
After pressing the joint ring(a), insert the drain hose(b) to drain direction.
a 
b 
CLEANING THE MACHINE 
CLEANING THE LINT FILTER
If the dregs are filled up in the lint filter after finishing the wash, push down and pull it out as shown in figure.
Remove the collected lint and rinse the filter net.
1
2
A
OVERFLOW FILTER
Pull the upper side of the overflow filter with two fingers into the hole ‘A’
in the direction of arrow as shown in the figure.
CLEANING THE WASH TUB
Wipe off strains on the cabinet and operation panel with soft cloth.
Do not use benzene, thinners, cleanser, or wax, nor scrub the washer with a brush. Painted surfaces or plastic parts will be damaged.
5