setting up your side-by-side refrigerator
PU E
Select the location where the filter is to install. (Model with the filter)
- If you wish to reassemble the water inlet and out- let sides of the filter during filter installation,
see the reference illustration.
-Cut the water line attached to the filter to the appropriate place after measuring the distance between the filter and the cold water tap.
LINE OUTLET
SIDE OF | 90 degree |
FILTER |
|
FILTER WATER | REFERENCE |
STTING01
WATER INLET | COUPLER |
SIDE OF FILTER |
|
Remove any residual matter inside the filter. (Model with the filter)
-Open the main water tap to check whether water is running through the water tube on the water inlet side of the filter.
-If water does not come out through the line, check whether the tap is open.
-Leave the tap open until clean water is running out and any residual matter that built up during manufacturing has been removed.
OUTLET SIDE | FILTER |
OF FILTER | |
WATER | WATER LINE |
|
Attach the filter lock stations. | TWO FILTER LOCK |
STATION |
-Hold the filter lock stations in the appropriate position (under the sink for example) and fix it tightly into place where to screw.
TWO FILTER LOCK
STATION
Secure the filter in position.
-Fix the filter in position, as shown in the figure on the right.
WATER TUBE |
| |
FILTER | FILTER | |
LOCK | ||
| ||
| STATIONS | |
TIGHTENING |
| |
BAND |
|
setting up _19