Samsung HT-TXQ120T/SAM Before Using Your Home Theater, Icons that will be used in manual

Before Reading the User's Manual

Make sure to check the following terms before reading the user manual.

Icons that will be used in manual

Icon	Term	Definition
		This involves a function available with DVD or
	DVD	DVD-R/DVD-RW discs that have been recorded and
		finalized in Video Mode.
	VCD	This involves a function available with a Video CD
		(CD-R or CD-RW).
	Super Audio CD	This involves a function available with a Super Audio
		CD (Single Layer, Dual Layer, Hybrid Layer).
	CD	This involves a function available with a data CD
		(CD-R or CD-RW).
	MP3	This involves a function available with CD-R/-RW discs.
	DivX	This involves a function available with MPEG4 discs.
		(DVD±R/RW, CD-R or CD-RW)
	JPEG	This involves a function available with CD-R/-RW discs.
	CAUTION	This involves a case where a function does not
		operate or settings may be cancelled.
	NOTE	This involves tips or instructions on the page that
		help each function operate.

• In this manual, the instructions marked with "DVD ( )" are applicable to DVD-VIDEO, DVD-AUDIO, and DVD-R/-RW discs that have been recorded in Video Mode and then finalized.

Where a particular DVD type is mentioned, it is indicated separately.

•If a DVD-R/-RW disc has not been recorded properly in DVD Video format, it will not be playable.

Before Using Your Home Theater ENG

To Operate your Samsung TV and the Home Theater with the HT-TXQ120’s Remote Control

The DVD Home Theater's remote can be used to control Samsung TVs.

1 Plug the subwoofer's power cord into the AC power supply.

Before plugging your system into a main socket, you must check the voltage setting (OPTIONAL). If the voltage of the socket does not correspond to the setting on the rear of

the unit, you may seriously damage your system.

2 Press the TV button to set the remote to TV mode.

3 Press the POWER button to turn on your Samsung TV with this remote.

4 Press the TV/VIDEO button to select VIDEO mode on your TV.

		VIDEO
5			OPERATION
	Press the DVD RECEIVER button to switch to DVD RECEIVER mode to

operate the DVD Home Theater.

6 Press the FUNCTION button on the main unit or DVD button on the remote to enable DVD/CD playback.

Selecting the Video Format

Press and hold the NT/PAL button on the remote controller for over 5 seconds while the power is turned off.

By default, the video format is set to <PAL>.

<NTSC> or <PAL> will appear in the display. At this time, press the NT/PAL button shortly to select between <NTSC> and <PAL>.

Each country has a different video format standard.

For normal playback, the video format of the disc must be the same as the video format of your TV.

24 25