Samsung CN15VOSN/VNT manual Regulatory Information, FCC Information, IC Compliance Notice

Page 31

Re Page 2 Monday, July 9, 2001 4:42 PM

Regulatory Information

FCC Information

User Instructions

The Federal Communications Commission Radio Frequency Interference Statement includes the following warning:

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television receptions, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

„Reorient or relocate the receiving antenna.

„Increase the separation between the equipment and receiver.

„Connect the equipment into an outlet on a circuit dif- ferent from that to which the receiver is connected.

„Consult the dealer or an experienced radio/TV tech- nician for help.

User Information

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

If necessary, consult your dealer or an experienced radio/television technician for additional suggestions. You may find the booklet called How to Identify and Resolve Radio/TV Interference Problems helpful. This booklet was prepared by the Federal Communications Commission. It is available from the U.S. Government Printing Office, Washington, DC 20402, Stock Number 004-000-00345-4.

Warning

User must use shielded signal interface cables to maintain FCC compliance for the product.

Declaration of conformity for products Marked with FCC Logo

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

The party responsible for product compliance:

SAMSUNG ELECTRONICS CO., LTD America QA Lab of Samsung

85 West Tasman Drive San Jose, CA 95134 USA Tel) 408-544-5124

Fax) 408-544-5191

Provided with this monitor is a detachable power supply cord with IEC320 style terminations. It may be suitable for connection to any UL Listed personal computer with similar configuration. Before making the connection, make sure the voltage rating of the computer convenience outlet is the same as the monitor and that the ampere rating of the computer convenience outlet is equal to or exceeds the monitor voltage rating.

For 120 Volt applications, use only UL Listed detachable power cord with NEMA configuration 5-15P type (parallel blades) plug cap. For 240 Volt applications use only UL Listed Detachable power supply cord with NEMA configuration 6-15P type (tandem blades) plug cap.

IC Compliance Notice

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing Equipment Regulations of ICES-003.

Cet appareil Numérique de classe B respecte toutes les exigences du Règlemont ICES-003 sur les équipements produisant des interférences au Canada.

MPR II Compliance

This monitor complies with SWEDAC(MPR II) recommendations for reduced electric and magnetic fields.

European Notice

Products with the CE Marking comply with both the EMC Directive (89/336/EEC), (92/31/EEC), (93/68/EEC) and the Low Voltage Directive (73/23/EEC) issued by the Commission of the European Community. Compliance with these directives implies conformity to the following European Norms:

„EN55022:1998 – Radio Frequency Interference

„EN55024:1998 – Electromagnetic Immunity

„EN61000-3-2:1995 + A1 + A2 – Power Line Harmonics

„EN61000-3-3:1995 – Voltage Fluctuations

„EN60950 – Product Safety.

Image 31
Contents SyncMaster 570V TFT SyncMaster 560V TFT For Better Display Resolution 1024 xTable of Contents Do not Open Safety InstructionsUnpacking Your Monitor Setting up an Ergonomic Workstation Setting up Your MonitorKensington Security Slot Or graphics card Connecting Your LCD MonitorJack to the DC power port on the back of your monitor Successfully installedMIC OUT jack Connecting Your Multimedia LCD MonitorCard Plug and Play Installing the Video DriverWindows PROPERTIES, Monitor tab, have Disk Self-Test Feature Check StfcVersion 4.00.950A Version 4.00.950BWarm-up Time Getting HelpMonitor User Controls Adjusting Your LCD MonitorAuto Adjustment Direct-Access FeaturesAutomatic Save OSD Lock/Unlock Setting slidebar Numeric value IndicatorOn Screen Display OSD BrightnessOSD functions and adjustments Accessing the menu systemBrightness Contrast Position Image LockColor Control ResetTemperature ColorTime LanguageMenu Position Menu DisplayDisplay Mode This screen shows the horizontal and vertical Audio Controls Adjusts the volume of the low sound„ Left Decrease volume „ Right Increase volume Adjusts the volume of the high soundAppendix PowerSaverTroubleshooting „ Move the computer’s mouse or Screen is blank „ The monitor is using its power PowerSaverDisplay Mode Management systemCheck the volume control on Documentation Troubleshooting problems AudioConnecting your Raise the volume Sound level isYour computer or sound Specifications DDC Data Horizontal Sync Not used Vertical Sync DDC Clock Pin D-sub connectorPin Assignments Red Green Green + H/V Sync BlueDisplay Modes Preset timing modesScreen Turn off your monitor and unplug its power cordChanging the Base Removing the baseAttaching a base Maintenance of Your LCD monitorMPR II Compliance Regulatory InformationFCC Information IC Compliance NoticePrinted on recyclable paper
Related manuals
Manual 30 pages 18.18 Kb Manual 30 pages 9.76 Kb Manual 30 pages 61.47 Kb