Samsung CN15VOSN/VNT manual Connecting Your LCD Monitor, Or graphics card, Successfully installed

Page 7

570V560V-E3p-28p Page 5 Monday, July 9, 2001 4:30 PM

Setting up Your Monitor

Connecting Your LCD Monitor

Figure 3. Cable connections

1

2

Turn off your computer and unplug its power cord.

Connect the signal cable to the 15-pin D-sub connector on the back of your monitor.

3

Connect the signal cable to the video port on your computer, video board, video card,

or graphics card.

4

Connect the power cord for your monitor to the DC adapter and connect the adapter

jack to the DC power port on the back of your monitor.

5

Plug the computer and monitor power cords into a nearby power mains outlet.

 

6

Turn your computer and monitor on. If your monitor displays an image, it has been

successfully installed.

7

If necessary, install the video driver for this monitor (see “Installing the Video Driver”

on page 7).

8

After your monitor has been fully installed, run Auto Adjustment (see page 11).

 

English 5

Image 7
Contents SyncMaster 570V TFT SyncMaster 560V TFT For Better Display Resolution 1024 xTable of Contents Do not Open Safety InstructionsUnpacking Your Monitor Setting up an Ergonomic Workstation Setting up Your MonitorKensington Security Slot Or graphics card Connecting Your LCD MonitorJack to the DC power port on the back of your monitor Successfully installedMIC OUT jack Connecting Your Multimedia LCD MonitorCard Plug and Play Installing the Video DriverWindows PROPERTIES, Monitor tab, have Disk Self-Test Feature Check StfcVersion 4.00.950A Version 4.00.950BWarm-up Time Getting HelpMonitor User Controls Adjusting Your LCD MonitorAuto Adjustment Direct-Access FeaturesAutomatic Save OSD Lock/Unlock Setting slidebar Numeric value IndicatorOn Screen Display OSD BrightnessOSD functions and adjustments Accessing the menu systemBrightness Contrast Position Image LockColor Control ResetTemperature ColorTime LanguageMenu Position Menu DisplayDisplay Mode This screen shows the horizontal and vertical Audio Controls Adjusts the volume of the low sound„ Left Decrease volume „ Right Increase volume Adjusts the volume of the high soundAppendix PowerSaverTroubleshooting „ Move the computer’s mouse or Screen is blank „ The monitor is using its power PowerSaverDisplay Mode Management systemCheck the volume control on Documentation Troubleshooting problems AudioConnecting your Raise the volume Sound level isYour computer or sound Specifications DDC Data Horizontal Sync Not used Vertical Sync DDC Clock Pin D-sub connectorPin Assignments Red Green Green + H/V Sync BlueDisplay Modes Preset timing modesScreen Turn off your monitor and unplug its power cordChanging the Base Removing the baseAttaching a base Maintenance of Your LCD monitorMPR II Compliance Regulatory InformationFCC Information IC Compliance NoticePrinted on recyclable paper
Related manuals
Manual 30 pages 18.18 Kb Manual 30 pages 9.76 Kb Manual 30 pages 61.47 Kb