Changing Direction of Door Opening, Plate

Installation Instructions

ADDING ELBOW FOR EXHAUST THROUGH BOTTOM OF CABINET

• Insert the elbow through the rear opening and connect

it to the dryer internal duct.

13CHANGING DIRECTION OF DOOR OPENING

• Apply duct tape on the joint between the dryer internal

duct and elbow, as shown on page 7.

CAUTION:

Internal duct joints must be secured with tape, otherwise they may separate and cause a safety hazard.

ADDING COVER PLATE TO REAR OF CABINET

PLATE

(KIT WE1M454)

Connect standard metal elbows and ducts to complete the exhaust system. Cover back opening with a plate (Kit WE1M454) available from your local service provider. Place dryer in final location.

WARNING-NEVER LEAVE THE BACK OPENING WITHOUT THE PLATE.

REMOVE 4

HINGE SCREWS.

ROTATE DOOR 180°

AND REINSTALL.

REMOVE 4 HOLE PLUGS AND PLACE THEM IN THE HOLES ON THE OPPOSITE SIDE.

Page 8

Image 8

GE PTDS650GMWT installation instructions Changing Direction of Door Opening, Adding Cover Plate to Rear of Cabinet

Contents

Before YOU Begin Read these instructions completely and carefully Preparing for Installation NEW Dryer Disconnecting GASRemoving Lint from Wall Exhaust Opening GAS Requirements Reconnecting GAS Leak Test Exhaust System Check List Electrical RequirementsExhaust Information Exhaust Connection Leveling DryerStandard Rear Exhaust Vented above floor level Leveling Legs Stand the Dryer Upright Near Metal FOIL-TYPE Transition Duct Connecting the Dryer To House VentRigid Metal Transition Duct Dryer Exhaust to RIGHT, Left or Bottom Cabinet TAB LocationAdding NEW Duct Bend TAB Remove Hinge Screws Rotate Door Reinstall Changing Direction of Door OpeningAdding Cover Plate to Rear of Cabinet Plate Servicing Connecting Inlet HosesWater Supply Requirements

GE PTDS650GMWT Changing Direction of Door Opening, Adding Cover Plate to Rear of Cabinet

Models: PTDS650GMWT