Samsung WA12KSEY/XSV manual Memory Course, Clean TUB Course, Delay Start, Heavy Course

Page 7

MEMORY COURSE

POWER

START/

(Memorize the functions frequently

HOLD

 

used, and you can use it easily when

 

 

washing the next time)

 

 

1.Put the laundry in the washer and press the POWER button to on.

Check to put the functions you need before washing.

Refer to the following instruction on how to set up the memory course.

2.Select the course button four times.

Selected functions are displayed on the control panel.

3.Press START/ HOLD button.

Put the detergent/softener in proportion to the water level and then close the lid.

How to set up memory course

1)Press the POWER button to on.

2)Press MEMORY button to on.

It is shown same as the beginning of Fuzzy course.

3)Select the functions frequently used manually

(such as water temperature, time of washing/drying and rinsing.)

4)Press the momory button one-second or more to input selected mode (Press the button until buzzer makes sound once more).

Press the START/HOLD butto to run input mode.

Repeat the above proceduce to change the Memory mode.

Even when power system turns OFF, your final input mode is memorized.

CLEAN TUB COURSE

POWER

START/

(in cleaning the washing tub)

HOLD

 

1.Press the POWER button.

2.Select the course button five times.

3.Press START/HOLD button.

Put the detergent in proportion to water level and close the lid.

Sock washing adjusted.

Water temperature select button only adjustable.

Ideal detergent : powder bleach

Remove the dirt in the outer wall of the

washing tub with powerful stream of current.

DELAY START

POWER

DELAY

START/

HOLD

START

 

 

 

1.Put the laundry in the washer

and press the POWER button to on.

Make sure to open the tab.

2.Press DELAY START course button.

1)Increase one hour more each press from 3 hours and you can select by maximum 19 hours.

2)After selected time is over, it finishes washing.

You can choose a course separately as you want.

3.Press START/ HOLD button.

Put the detergent in proportion to water level and close the lid.

Be sure of putting the detergent into the liquid soap device.

In case of putting the detergent into the laundry directly, it may be discolored according as the reservation is longer.

Press the power button in order to cancel the reservation.

It could be finished at slightly different time due to the water pressure.

HEAVY COURSE

POWER

HEAVY

START/

(For Jeans or laundry

HOLD

 

 

 

 

 

with heavy dirt)

 

 

 

1.Put the laundry in the washer and press the POWER button to on.

2.Select HEAVY course button.

3.Press START/HOLD button.

Put the detergent/softener in proportion to the water level and then close the lid.

Here adjusted soaking course during 20 minutes to remove the heavy dirt at the collar of laundry (When need more soaking, press wash button select 40 minute soaking time manually.

The washing board and tub spinning in the opposition way gives great efficiency washing.

SUPER RINSE COURSE POWER

SUPER

START/

 

RINSE

HOLD

6

Image 7
Contents Troubleshooting Specifications Manual Functions Installation & MaintenanceFeatures Safety Instructions Water Drain Hose Spin Basket Power Cord Ground LeadFilter LID Pulsator Front Control PanelControl Panel Speedy Course Washing ProcedureFuzzy Course Power Blanket CourseMemory Course Clean TUB CourseDelay Start Super Rinse Course PowerManual Functions Environment Installation & MaintenanceLevelling TypeB Connecting the Water Supply HoseCase of PUMP-DRAINED Washer HOW to ADD the Fabric SoftenerHOW to PUT the Detergent Assembling the RAT Protection PanelHOW to Clean the Filter Water Supply Connector FilterPump drained washer Water Dose not Drain TroubleshootingWashing Machine Wont Work Check Your Voltage Water is not SuppliedCase the Need for Servicing Arises Specifications