WATER SUPPLY CONNECTOR FILTER
1.Pull out the filter and wash well.
inlet water valve
2.Pull in the filter and connect the hose to the inlet water valve tightly.
3.Check if there is a leakage. Note to tighten up the connector.
CLEANING THE FILTER NET Clean the filter net often to keep the washer clean.
1.Push the upper part of the filter and pull in.
2. Open the cover as | 3. Clean the filter. | 4. Close the cover and insert the |
shown in the figure. |
| lower part of the filter in the |
|
| basket first and then push the |
|
| filter with "click" sound . |
1. Push up and | 2. Remove the collected | 3. Clean the filter. | 4. Pull down the filter net. |
pull out the filter net. | lint from the filter net. |
|
|
|
|
|
|
HOW TO CLEAN THE FILTER
1. Place a rag under the washer filter not to wet the floor.
2. Rotate the filter counterclockwise and pull out the filter.
3. Remove dirts and rotate the filter clockwise until it locks in position.
(pump drained washer)
1.Place a rag under washer filter not to wet the floor.
2.Turn the
3.Take the filter out and remove dirts.
4.Reassemble in reverse order.
11