Samsung SW75USPIW/XSA manual HOW to Wash Automatically Depends on the Laundry

Page 9

HOW TO WASH AUTOMATICALLY DEPENDS ON THE LAUNDRY

Before starting washing, check the following;

Connect the water supply hose to the water tap. Leave a tap open. Plug the power cord in. Make sure to lay down the drain hose.

Washing for the first time

Before washing clothes for the first time, you must run a complete cycle without clothes.

To do this:

1.Press the Power button.

2.Open the detergent drawer and insert a little detergent.

3.Turn on the water supply to the washing machine.

4.Press the Start/Hold button.

This will remove any water from the manufacturer’s test run remaining in the machine.

Special notes!

Automatic Sensing Function

At every course (except Clean tub, delicate course) the amount of laundry is automatically sensed and then appropriate water level, washing time, rinsing cycle, and spinning time are automatically selected for automatic washing.

After the power is on, a course is selected and Start/Hold button is pressed. Then, the washing board starts spinning without water. This action senses how much laundry is in the washing basket, not a machine problem. After this sensing process, water supplies automatically.

Adding Detergent and Softener

It senses the amount of laundry and indicates the water level and amount of detergent. Then, it starts water supply right away.

During the water supply, it is possible to open the detergent box and add detergent. However, it is better to press Start/Hold button to stop water supply and add detergent. Close the lid and press Start/Hold button again. This way is much more convenient.

If the softener is inserted in the softener dispenser, it automatically adds in at the last rinsing cycle.

Put the laundry into the washer and add detergent, too.

Be careful not to overload. Use right detergent for the fabrics you are washing.

If the lid is open while running, the washing machine is stopped automatically for safety. (Except, water supply continues while the lid is open.)

When hot water is selected, both cold and hot water are supplied for the first 20 seconds in order to protect the clothes.

Possible to control the washing time, rinsing cycle, and spinning time at every course during the washing.

01 Setting up your washer

Setting up your washer_9

SW75USPIW-02459M_EN.indd 9

2008-02-20 ¿ÀÈÄ 12:09:49

Image 9
Contents Washing Machine  Water Saving course FeaturesSafety instructions 4Safety instructions Contents Description of Part Setting up your washerCheckpoints Before Starting Washing Checking Before Washing and Caring for GarmentsCaring for Clothes Before Washing Before starting washing, check the following HOW to Wash Automatically Depends on the LaundryControl Panel Wash Button TIME, ErrorSoak Button Remaining TimeFuzzy Course Blanket CourseDelicate Course Clean TUB Course Keeping the TUB CleanQuick Course Super Clean Course Delay StartEasy Course Manual functions Connecting the Water Supply Hose Installation & maintenanceEnvironment LevellingInstallation & maintenance17 HOW to Connect the Drain Hose Assembling the RAT Protection PanelCase of PUMP-DRAINED Washer HOW to PUT the Detergent HOW to ADD the Fabric SoftenerWater Supply Connector Filter Cleaning the Filter HOW to Clean the Pump FilterPrecautions Problem Check TroubleshootingWashing machine won’t work? Problem Check & SolutionSW75USP SpecificationCall Or Visit US Online AT Questions or COMMENTS?