Samsung MAX-X66R/EDC manual Setting the Clock, Press ENTER/PRGM

DEMO/DIMMER function

Setting the Clock

ENG

All functions available on the system can be viewed on the display and the display's brightness can be switched between "on" and "off".

1	Press the DEMO button.
	Result: All functions available on the system appear on the front
	panel display.
	Each of these are explained in detail in this guide. Please refer to
	the relevant section.
2	Press the DIMMER button.
	Result: The Dimmer function is selected and the display darkens.
3	Press the DIMMER button once again to brighten the front panel dis-
	play.

A display brightness control can only be performed while the system power is on.

12,3

Your system is equipped with a clock which allows you to turn your system on and off automatically.

You should set the clock:

When you first purchase the mini-compact system

After a power failure

After unplugging the unit

For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.

1	Switch the system on by pressing STANDBY/ON.
2	Press TIMER/CLOCK twice.
	Result: CLOCK is displayed.
3	Press ENTER/PRGM..
	Result: The hour flashes.
4
	To...	Turn the MULTI JOG knob to the...
	Increase the hours	Right
	Decrease the hours	Left
5	When the correct hour is displayed, press ENTER/PRGM..
	Result: The minutes flash.
6
	To...	Turn the MULTI JOG knob to the...
	Increase the minutes	Right
	Decrease the minutes	Left
7	When the correct time is displayed, press ENTER/PRGM..
	Result: The clock starts and is displayed, even when the system is in
	standby mode.

You can display the time, even when you are using another function, by pressing TIMER/CLOCK once.

You can also use / buttons on the panel front or TUNING / on the remote control to instead of MULTI JOG knob in step 4, 6.

4,6	4,6
1	3,5,7
	4,6
2

8