Samsung MAXZS530RH/ELS Connecting your System to the Power Supply, Connecting the Loudspeakers

Where to Install Your

Mini-Compact System

To take full advantage of your new mini-compact system, fol- low these installation instructions before connecting the unit.

Install the system on a flat, stable surface.

Never place this unit on carpeting.

Never place this unit in an outdoor area.

Maintain an open space of approximately 6 inches (15 cm) on the sides and rear of the system, for ventilation purposes.

Make sure that you have enough room to open the compact disc compartment easily.

Place the loudspeakers at a reasonable distance on either side of the system to ensure good stereo sound.

Direct the loudspeakers towards the listening area.

For optimum performance, make sure that both speakers are placed at an equal distance above the floor.

Connecting your System to the Power Supply

The main lead must be plugged into an appropriate socket.

Before plugging your system into a main socket, you must check the voltage.

1	Plug the main lead (marked AC Cord on the rear of the system) into
	an appropriate socket.
2	Press the Standby/on button to switch your mini-compact system on.

Connecting the Loudspeakers

GB

The loudspeaker connector terminals are located on the rear of the system.

There are four terminals on the system:

Two for the left speaker (marked L)

Two for the right speaker (marked R)

To achieve the correct sound quality, connect the:

Red wire to the + terminals

Black wire to the – terminals

1	To connect a wire to a terminal, push the tab as far as it will go:
	To the right on the system
2	Insert the wire, up to the plastic sheathing, in the hole.
3	Push the tab back:
	To the left on the system, until it clicks into place
	To the top on the loudspeaker
	Result: The wire is pinched and held firmly in place.
4	Repeat the operation for each wire.

L

R

7