Connecting to an External Source
GB
The auxiliary input can be used to take advantage of the sound quality of your
Examples: 
A television
A video disc player
A
To connect the external source, the source must have an audio output. In addition, you need an RCA connection cable.
1 Set the system to standby mode and disconnect it and the external source from the main.
2 Connect the audio cable to the rear of the
Connect the... | To the connector marked... |
Red jack | R (right) |
White jack | L (left) |
| For optimum sound quality, do not invert the right and left | |
| channels. |
|
3 | Plug the system back into the main socket and press Standby/On to | |
| switch it on. |
|
4 | Select the AUX source by pressing AUX. | |
| Result: AUX is displayed. | |
5 | Switch the external source on. | |
6 | Adjust the volume and balance as required: | |
| Volume | Equalizer |
Example: You can watch a film and take advantage of stereo sound provided that the original sound track is in stereo (as if you were in a cinema).
CD Digital Out Jack
This unit can output CD digital sound signals through this jack. Use an optical cable to connect digital audio equipment. (DAT deck, MD recorder, etc.).
Remove the dust cap (1) from the CD DIGITAL OUT jack. Then, connect an optical cable plug to the CD DIGITAL OUT jack.
(1)
When the CD DIGITAL OUT jack is not being used
Attach the supplied dust cap.
Connecting the Loudspeakers
The loudspeaker connector terminals are located on the rear of the system.
There are four terminals on the system:
Two for the left speaker (marked L)
Two for the right speaker (marked R)
To achieve the correct sound quality, connect the:
Red wire to the + terminals
Black wire to the – terminals
1 | To connect a wire to a terminal, push the tab as far as it will go: | |||||||||
| To the right on the system | |||||||||
2 | Insert the wire, up to the plastic sheathing, in the hole. | |||||||||
3 | Push the tab back: | |||||||||
| To the left on the system, until it clicks into place | |||||||||
| To the top on the loudspeaker | |||||||||
| Result: The wire is pinched and held firmly in place. | |||||||||
4 | Repeat the operation for each wire. | |||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Directions in Installing Speaker
Installation in a place near heating apparatus, under direct lay of light or with high humidity may cause performance degradation of the speaker.
Do not install on the wall or on a high place of pole or other unstable place to prevent any safety accident caused by falling of the speaker.
Do not take the speaker apart from TV or computer monitor. The speaker near the TV or computer monitor may influence the quality of the screen display.
8