Samsung DVD-H40E/EUR Using the TV Button on the Remote Control, By means of RF Coaxial Cable

Connecting DHR(DVD HDD Recorder) to a Satellite Receiver or Other Equipment

You can connect your DHR to a Satellite receiver or other DHR using the SCART cable if the appropriate outputs are available on the equipment chosen. The following illustrations give a few examples of the connection possibilities.

1. AV2 IN: By means of 21-pin Scart Cable

Plug the SCART Cable with satellite receiver or other equipment into the AV2 (DEC./EXT.) jack on the rear of the DHR. After making this connection, select the source by pressing the INPUT SEL. button for the AV2 input sources.

2. By means of RF Coaxial Cable

After making this connection, you must preset the station received through the satellite tuner.

RF output channel of the satellite receiver should be adjusted away from channel 36, which is used by the DHR, e.g. re-adjust to channel 39.

Satellite Receiver or other Equipment Aerial

Aerial Connector

1

2

SCART Cable

RF coaxial cable

Using the TV Button on the Remote Control

Your DHR remote control will work with Samsung televisions and compatible brands.

To determine whether your television is compatible, follow the instructions below.

1 Switch your television on.

2Point the remote control towards the television.

3

3 Hold down the TV button and enter the two-figure code corresponding to the brand of your television, by pressing the appropriate numeric buttons.

Brand		Codes	Brand	Codes
	SAMSUNG	01 to 06	PHILIPS	02, 20, 22
	AKAI	09, 23	SABA	13, 14, 22 to 24
	GRUNDIG	09, 17, 21	SONY	15, 16
	LOEWE	02	THOMSON	13, 14, 24
	PANASONIC	08, 23 to 27	TOSHIBA	07, 16 to 19, 21

•If your television is compatible with the remote control, it will be switched off. It is now programmed to operate with the remote control.

➢◆ If several codes are indicated for your television brand,

try each one in turn until you find one that works.

◆When you change the batteries in the remote control, you must reprogram the code, following the same procedure.

You can control the television using the following buttons.

Button	Function
STANDBY/ON	Used to switch the television on and off.
INPUT SEL.	Used to select an external source.
VOL. + or -	Used to adjust the volume of the television.
PROG. Up or Down	Used to select the required channel.
TV MUTE	Used to toggle the sound on and off.

➢The various functions will not necessarily work on all televisions. If you encounter problems, operate the television directly.

20 21