Basic Connections/Auto Setup DVD/HDD View

Basic Connections/Auto Setup

DVD/HDD View

from antenna

or cable

To TV’s

Antenna Input

In this section, you will connect the DHR to your television and run Auto Setup, which automatically searches for channels and sets the

player’s internal clock.

1Connect the RF antenna cable from your indoor/outdoor antenna or cable wall outlet to the IN(FROM ANT.) jack on the rear panel of the DHR

2Choose one of the following methods to connect the DHR to your TV:

RF Connection:

Connect the supplied RF antenna cable from the OUT(TO TV) jack on the rear panel of the DHR to your television’s Antenna Input.

Line Connection:

Connect an RCA-type audio/video cable(red, white, yellow) from the LINE OUT jacks on the rear panel of the DHR to your television’s Line In jacks.

Use red for right audio, white for left audio, and yellow for video.

➢It is recommended that you use the Line Connection if your TV is equipped with RCA jacks.

The DHR uses one set of controls to operate DVD & HDD. The following buttons are helpful in successfully controlling each one.

1Press the STANDBY/ON button on the remote control or the front panel to turn on the DHR.

2Press the DVD button on the remote control or on the front panel when you want to control the DVD deck.

•The DVD indicator will light on the Front Panel Display to show that the DVD deck is selected.

3Press again the HDD button on the remote control or on the front panel when you want to control the HDD.

•The HDD indicator will light on the Front Panel Display to show that the HDD is selected.

DVD INITIAL SCREEN	HDD INITIAL SCREEN
LOADING	AV1

Auto Setup

3	Connect the DHR power cord to a standard 220~24V/50Hz
	wall outlet. Then power is automatically turned on.
	•	Don’t press any buttons on the DHR or remote during auto setup.
		“AUTO” blinks while the DHR runs an auto setup procedure, where
		it will automatically search for all active channels and set the clock.
	•	When Auto setting has been completed, the front panel displays

Basic DVD Playback

Notice

Audio Options

Check Antennas and TV Cable Connection

lnstructions Move Enter Return Menu Exit

Auto Setup

	Auto CH Search
	Audio Options
	DisplayPlease OptionsWait

			46%
lnstructions	Move	Enter Return Menu Exit
lnstructions	Move	Enter Return Menu Exit

Auto Setup

Notice

Audio Options

Now searchingN the clock

	the current time.
	• If Auto Clock set is unable to find the current time,
	you can set the clock manually;See page 29.

4	Press the STANDBY/ON button on your TV.

5	Set TV to Channel 21~69 or AV.
	Be sure to use the same channel you selected.

➢◆ Even if you plan to use the S-Video Output, you MUST connect the DHR to your television with either the standard RF or the AV Out connection.

This enables you to operate the DHR setup menu.

Follow these instructions to playback a DVD.

1Open disc drawer.

•Press the Open/Close button on the remote control or front panel.

2Insert disc.

•Place the disc in the drawer with the label side of the disc facing up. If the disc has two sides, orient the disc with the desired label facing up.

3Close disc drawer.

•Press the Open/Close button on the remote control or front panel to close the disc drawer.

4Press the ❿II(Play/Pause) button on the remote control or front panel.

•Many discs will begin playback automatically when the disc drawer closes.

•If the DVD has a disc menu, or more than one title, the disc menu may appear.

5Additional DVD options.

•See pages 45~56.

lnstructions

Move

Enter Return Menu Exit