3 – Installation (continued)
3-4 Installation Across Aisle
Note: Follow the instructions in this section only if the SRCABLELADDER accessory will be installed across an aisle. If the SRCABLELADDER accessory will be installed within a row of enclosures, follow the instructions in Section
1Insert four assembly brackets A into the ends of the ladder. The hooked ends of the brackets should be exposed. When the ladder is oriented so that the ladder’s rungs are above the ladder’s side rails, the hooked ends of the brackets should point down, as shown in the drawing.
2Align the pin holes in the ladder sections with the pin holes in the assembly brackets and insert clevis pins B into the pin holes (4 total). This step may be omitted to provide additional installation flexibility, but installing the pins will make the
SRCABLELADDER accessory more stable. Warning: If you choose not to install the clevis pins, make sure at least 25% of the length of each assembly bracket is inside the ladder.
3After inserting the clevis pins, insert a cotter pin C through the hole at the end of each clevis pin. (The straight section of the cotter pin goes through the hole.)
4Using an assistant, lift the SRCABLELADDER accessory (rungs upward) and insert the exposed hook ends of the assembly brackets D into the corresponding slots E in the SRCABLETRAY accessories installed at the top of each enclosure. The hooks should fit the slots securely by sliding down to engage the edge of the slot. Note: There are two levels of slots. Use the slots that match your application best.
| A |
1 |
|
| B |
2 | B |
| |
| C |
3 |
E |
D |
4 |
5