4.Remove the filter’s protective cap and then position and insert the filter into the filter housing.
5.Slowly turn the water filter clockwise 90º to align with the indication mark on the cover, locking the filter in position. Make sure that the indicator is lined up with the “lock” position. Remember, do not
Cover filter
Separation |
|
|
|
| Align the indication |
|
|
|
| ||
of red cap |
|
|
|
| mark with lock position |
|
If your model contains wine shelf, you should remove the wine shelf before installing water filters.
Removing any residual matter inside the water supply line after installing filter.
1. | Turn ON the main water supply & turn OFF the valve to the |
|
| water supply line. | Ice |
2. | Run water through the dispenser until the water runs clear |
|
| (approx. 1L). This will clean the water supply system and |
|
| remove air from the lines. |
|
3. | Additional flushing may be required in some households. |
|
4. | Open the refrigerator door and make sure there are no |
|
| water leaks coming from the water filter. |
|
A newly installed water filter cartridge may cause water to briefly spurt from the water dispenser. This is due to air getting into the line. It should pose no problem to operation.
Water
Check the amount of water supplied to the ice tray. (Optional)
1.Lift up the icemaker bucket and gently pull out of the freezer.
2.When you press the Test button, the ice cube container is filled with water from the water supply tap. Check to make sure the amount of water is correct(see the illustration below).
If the water level is too low, the ice cubes will be small. This is a water pressure problem from with in the main water pipes, not the refrigerator.
1
Feeler Arm 
Ice maker | 2 |
Check the water level
Test button
20_ setting up | English |