Close Main |
Water pipe |
Close Main | NO GAP |
Water pipe |
|
4.After connecting the water supply to the water
filter, turn your main water supply back on and dispense about 1l to clear and prime the water
filter.
Connecting the water line to the refrigerator
1.Remove the dust cap from the water line on the rear of the unit and fi t a compression nut from the install kit.
2.Remove the water pipe from the install kit and fi t a compression nut to one end.
3.Join the two pipes together using the compression joint from the install kit ensuring that the joint is water tight.
4.Join the other end of the install pipe to the main water supply and turn on the water to check for leaks.
Loosen a | Remove |
cap |
•Samsung Warranty does not cover WATER LINE INSTALLATION.
•The cost of connection to a water supply is at the customer expense, unless included in the delivery charge (refer to the delivery agreement with the seller)
•Please contact Plumber or Authorised Installer for the installation if needed.
•If Water leakage occurs due to improper installation, Please contact installer.
INSTALLING THE WATER DISPENSER LINE
For Exterior model
Parts for water line Installation
Pipe connector Water line fi xer and screws
01 SETTING UP
Water Line |
from unit |
Water Line |
from Kit |
No gap |
Water line | Purifi er | Purifi er |
Only connect the water line to a drinkable water source.
If you have to repair or disassemble the water line, cut off 6.5mm of the plastic tubing to make sure you get a snug,
Before being used, the leakage in CAUTION these places should be examined
Connecting to the water supply line
Connect the water pipe with coupler and tap.
1.Close the main water tap.
2.Connect coupler “A” to the tap.
CAUTION
The water line must be connected to the cold water pipe. If it is connected to the hot water pipe, it may cause the purifi er to malfunction.
setting up _13
2011.7.14 9:53:1 AM |