There is no image on the screen.
Is the power indicator on the monitor blinking at 1 second intervals?
Hz,, the display will work properly but the "Not Optimum
Mode","Recommended Mode 1600 X 1200 60 Hz" message appears for one minute and then disappears.
Please change to the recommended mode during this
(The message is displayed again if the system is rebooted.)
The monitor is in PowerSaver mode.
press a key on the keyboard to activate the monitor and restore the image on the screen.
If there is still no image, press the ' (Enter/Source)' button.
Then press any key on the keyboard again to activate the monitor and restore the image on the screen.
Is the monitor connected using the DVI cable?
I cannot see | Have you locked the On |
the On Screen | Screen Display (OSD) |
Display. | Menu to prevent changes? |
The screen | Is the screen displaying |
shows strange | only one color as if looking |
colors or just | at the screen through a |
black and | cellophane paper? |
white. | Have the screen colors |
| |
| become strange after |
| running a program or due |
| to a crash between |
| applications? |
You may get a blank screen if you boot the system before you connect the DVI cable, or disconnect and then reconnect the DVI cable while the system is running as certain types of graphic cards do not send out video signals.
Connect the DVI cable and then reboot the system.
Unlock the OSD by pressing the [] button for at least 5 seconds.
Check the signal cable connection. Make sure the video card is fully inserted in it's slot.
Reboot the computer.
The screen suddenly has become unbalanced.
Has the video card been set properly?
Have you changed the video card or the driver?
Have you adjusted the resolution or frequency to the monitor?
Set the video card by referring to the video card manual.
Adjust screen image position and size using the OSD.
Adjust the resolution and frequency at the video card.
(Refer to the Preset Timing Modes).
The screen can be unbalanced due to the cycle of the video card signals. Readjust Position by referring to the OSD.
The screen is | Have you adjusted the |
out of focus or | resolution or frequency on |
OSD cannot be | the monitor? |
adjusted. |
|
LED is blinking | Is the frequency properly |
but no images | adjusted when checking |
on the screen. | the Display Timing on the |
| menu? |
Adjust the resolution and frequency of the video card.
(Refer to the Preset Timing Modes).
Adjust the frequency properly by referring to the video card manual and the Preset Timing Modes.
(The maximum frequency per resolution may differ from product to product.)