Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Operation
Note: FAILURE TO FILL THE ULTRASONIC CLEANER WITH WATER OR A
ROSIVE CLEANING MATERIAL BEFORE USING WILL SEVERELY DAMAGE IT AND VOID THE WARRANTY.
1.Make certain that the Cleaner ON/OFF Switch is in the “OFF” position. Make cer- tain that the Ultrasonic Cleaner is unplugged. Insert one end of the Cord into the Ultrasonic Cleaner, and the other end into a 120 V~ outlet.
2.Fill the tank so that the product is covered and the fluid is between the minimum and maximum fill lines. Fill the Cleaner with water or an appropriate ultrasonic cleaning fluid. Specially formulated ultrasonic cleaning materials are safe for most materials. Plastic safe cleaning fluids are recommended. Use water that is lukewarm (under 149° F). Excessively hot fluid will damage the Transducer.
3.Place article to be cleaned onto the Plastic Screen (8) inside of the Tank (9). Close the Tank Lid.
4.“180” will be displayed on the readout. 180 S (seconds, or three minutes) is the typical cycle for cleaning.
5.The Ultrasonic Cleaner has an automatic
Choosing a cleaning cycle
1.You can choose from 5 cleaning cycles: 90S, 180S, 280S, 380S, 480S.
2.Press “SET” to choose a cleaning
3.On some occasions, the initial cleaning may not adequately clean the article. A second period of cleaning usually finishes the cleaning process. Pressing the “ON” Button will restart the cycle.
3.To pause or stop the cycle, press “OFF”.
SKU 95563 | For technical questions, please call | Page |