CD Operation
Programming the disc tracks
Programming tracks is possible when playback is stopped. Up to 40 tracks can be stored in the memory in any order.
1Load the desired discs on the disc tray (refer to “Loading discs”).
2Press PROGRAM to start programming. ➜ PROG starts flashing.
3Press CD 1/2/3 to select a disc.
4Press í or ë repeatedly to select the desired track.
5Press PROGRAM to store the track.
●Repeat steps
6To end programming, press Ç once .
➜PROG stays and the programme mode remains active.
➜The total number of tracks programmed and the total playing time are displayed.
7To start programme play, pressÉÅ.
➜"PLAY PROGRAM" is displayed.
Notes:
–If the total playing time is more than "99:59" or if one of the programmed tracks has a number greater than 30, then
–If you attempt to programme more than 40 tracks, "FULL" is displayed.
–During programming, if no button is pressed within 20 seconds, the system will exit the programme mode automatically.
To review the programme
●Stop playback and press í or ë repeatedly.
●To exit review mode, press Ç.
Erasing the programme
●Press Ç once when playback is stopped or twice during playback.
➜ PROG disappears and "PROGRAM CLEARED" is displayed.
Note:
–The programme will be erased when the system is disconnected from the power supply or when the disc tray is opened.
For Recording, please refer to “Tape Operation/Recording”.
English
17