Motorola FW-C155 manual Important notes for users in the U.K, Mains plug, How to connect a plug

Page 2

Important notes for users in the U.K.

Mains plug

This apparatus is fitted with an approved 13 Amp plug. To change a fuse in this type of plug proceed as follows:

1Remove fuse cover and fuse.

2Fix new fuse which should be a BS1362 5 Amp, A.S.T.A. or BSI approved type.

3Refit the fuse cover.

If the fitted plug is not suitable for your socket outlets, it should be cut off and an appropriate plug fitted in its place.

If the mains plug contains a fuse, this should have a value of 5 Amp. If a plug without a fuse is used, the fuse at the distribution board should not be greater than 5 Amp.

Note: The severed plug must be disposed of to avoid a possible shock hazard should it be inserted into a 13 Amp socket elsewhere.

How to connect a plug

The wires in the mains lead are coloured with the following code: blue = neutral (N), brown = live (L).

As these colours may not correspond with the colour markings identifying the terminals in your plug, proceed as follows:

–Connect the blue wire to the terminal marked N or coloured black.

–Connect the brown wire to the terminal marked L or coloured red.

–Do not connect either wire to the earth terminal in the plug, marked E (or e) or coloured green (or green and yellow).

Before replacing the plug cover, make certain that the cord grip is clamped over the sheath of the lead - not simply over the two wires.

Copyright in the U.K.

Recording and playback of material may require consent. See Copyright Act 1956 and The Performer’s Protection Acts 1958 to 1972.

Italia

DICHIARAZIONE DI CONFORMITA’

Si dichiara che l’apparecchio FW-C155 Philips risponde alle prescrizioni dell’art. 2 comma 1 del D.M. 28 Agosto 1995 n. 548.

Fatto a Eindhoven

Philips Consumer Electronics

Philips, Glaslaan 2

5616 JB Eindhoven,The Netherlands

Norge

Typeskilt finnes på apparatens underside.

Observer: Nettbryteren er sekundert innkoplet. Den innebygde netdelen er derfor ikke frakoplet nettet så lenge apparatet er tilsluttet nettkontakten.

For å redusere faren for brann eller elektrisk støt, skal apparatet ikke utsettes for regn eller fuktighet.

CAUTION

Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation.

2

Page 1 Page 3
Image 2
Page 1 Page 3
Contents C155 Mains plug How to connect a plugImportant notes for users in the U.K Copyright in the U.KDSC Klass 1 laseraparat Index Contents General Information Supplied accessoriesSafety information AcknowledgementRear connections PowerPreparations Antennas ConnectionSpeakers Connection Front Speakers Inserting batteries into the remote controlFM Antenna Controls on the system and remote control Shuffle ControlsRepeat ¡ MuteBasic Functions First time setup/power upTo reinstall Plug and Play Plug and PlaySwitching the system to standby mode Demonstration modeSwitching the system on Dim modeVolume control Sound controlLoading discs CD OperationDiscs for playback Replacing discs during playback Playing discsSelecting a desired track/passage Repeat and ShuffleTo review the programme Programming the disc tracksErasing the programme Automatic Preset Programming Tuning to radio stationsStoring preset radio stations To begin automatic preset from a desired preset numberErasing a preset radio station Tuning to preset radio stationsPlaying tapes Tape Operation/RecordingLoading tape To playback a selected tape deckPreparation for recording Rewinding / Fast forwardingGeneral information on recording One touch recordingTo stop dubbing CD Synchronised start recordingDubbing tapes Timer setting Clock / TimerClock setting To exit without storing the settingActivating the timer for the same preset Sleep timer settingDeactivating the timer To deactivate the sleep timerSpecifications Problem Solution MaintenanceTroubleshooting CD OperationTape OPERATION/RECORDING
Top Page Image Contents