Samsung MM-E460D/XE manual Setting the Clock, Timer Function, Enter

Basic Functions

Setting the Clock

For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.

1.Switch the system on by pressing the POWER button.

2.Press TIMER/CLOCK button and then press the ENTER button.

Result: "CLOCK" is displayed.	TIMER
	CLOCK

3. Press ENTER.

Result: The hour flashes. `` Increase the hours:$ `` Decrease the hours:%

4.When the correct hour is displayed, press

ENTER.

Result: The minutes flashes.

`` Increase the minutes:$

`` Decrease the minutes:%

5.When the correct minute is displayed, press

ENTER.

Result: " TIMER" appears in the display.

`` The current time is now set.

✎✎NOTE

`` You can display the time, even when you are using another

function, by pressing the TIMER/CLOCK button once. `` You can also use [ or ] on the front panel instead of

$,%buttons in step 3,4.

Timer Function

The timer enables you to switch the system on or off at specific times automatically.

`` Before setting the timer, check that the current time is correct.

`` For each step, you have a few seconds to set the required options. If you exceed this time, you must start again.

`` If you no longer want the system to switch on or off automatically, you must cancel the timer by pressing the TIMER ON/OFF button.

Example: You wish to wake up to music every morning.

1. Switch the system on by pressing the	TIMER
POWER button.	CLOCK

2. Press the TIMER/CLOCK button and then press $ or % buttons until TIMER is displayed.

3.Press the ENTER button.

Result: ON is displayed for a few seconds, you can set the timer switch-on time.

4.Set the timer switch-on time.

aPress the $ or %button.

bPress the ENTER button. Result: The minutes flash.

cPress the $ or % button.

dPress the ENTER button.

Result: OFF is displayed for a few seconds, you can now set the timer switch-off time.

5.Set the timer switch-off time. a Press the $ or % button. b Press the ENTER button.

Result: The minutes flash.

cPress the $ or % button.

dPress the ENTER button.

Result: VOL XX is displayed, where XX corresponds to the volume already set.

6.Press $ or % button to adjust the volume level and press the ENTER button.

Result: The source to be selected is displayed.

7.Press the $ or % button to select the desired source to be played when the system switches on.

`` FM (radio) : a Press the ENTER button.

b Select a preset station by press the $ or % button.

`` DVD/CD (compact disc): Load one audio CD.

`` USB : Connect the USB device.

30 English